MainStack.qml

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
LEAH-1937: UI: Translation

- Removed not used NoCANBUS development settings.

- Added the two systemLocale and systemLanguage in the Settings singleton class, to be accessed by _Setting in one place.

- Renamed the isValid method in the Settings class to exists for clarity.

- Added local to the filename method in Settings to get the setting file name with the defined locale.

- Made the Category of the settings order to set eSettingsSystem at top, to get the locale first and then read the rest of the settings files according that setting.

- Separated the parse section from the read method to simplify the read function.

- Two big logic in Settings::read has changed:

1. the read won't read any conf file in the settings path anymore, since the order is not important and each file existance.

2. the Settings::read now reads a file and parse it after in oppose to read all files and the parse them. That is mainly because we need to make decision base on the content of the setting files (System.conf in this case for now)

- Renamed the Settings::save to saveSystem for clarification, since that is the only writable setting, and that does not have locale too.

  1. … 10 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 23 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 38 more files in changeset.
DEN-16959 UI: Navigate to the "Settings Screen" if HD is in service mode.

- Added the OpMode_service for the UI to go to the settings screen after the application relaunch if the HD is in service more.

- Since the UI will not go to the service mode unless user enter the password we have no security issue.

- It is expected with this fix we won't need to do hardware reset of the HD and makes the manufacturing lot easier.

Enable registration mode - initial implementation hesitations

  1. … 9 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 8 more files in changeset.
DEN-16785: Make Chem Disinfect and Chem Flush Disinfect Buttons Invisible per Instit Config Status

- Added code to application controller to call for request institutional record.

- Added code in the disinfect stack qml to dynamically adjust the disinfect buttons upon enable chemical disinfect value

- Changed the status of chemical disinfect in the institutional record to enabled or disabled from 1 or 0

DEN-16785: Make Chem Disinfect and Chem Flush Disinfect Buttons Invisible per Instit Config Status

- used the itemVisible to hide the chemical flush and checmical disinfect.

- fixed the institutional model class comment.

- made the enableChemicaldisinfect enabled/true by default.

DEN-16784: BACK Button Appears during Disinfection Screen after Ending Treatment

- Fixed the disinfect back button being visible on after treatment disinfection.

- Set the hasCancel to false when op_mode sets back to the StandbyWaitTreatment.

- Removed the disinfect back button hide on touch.

  1. … 7 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 8 more files in changeset.
DEN-16784: BACK Button Appears during Disinfection Screen after Ending Treatment

- Fixed the disinfect back button being visible on after treatment disinfection.

- Set the hasCancel to false when op_mode sets back to the StandbyWaitTreatment.

- Removed the disinfect back button hide on touch.

  1. … 2 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 612 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 5 more files in changeset.
DEN-16637, DEN-16640, DEN-16641 : P1_Staging Dry-Run found issues.

DEN-16637: SW: Top Alarm on Debug Screen Does Not Change When Alarm is Cleared

DEN-16640: SW: Blood Measurement Interval Set to OFF During Treatment When Set to 5 min in Pre-treatment

DEN-16641: UI: Heparin Syringe Installation Screen Missing

  1. … 4 more files in changeset.
DEN-16637, DEN-16640, DEN-16641 : P1_Staging Dry-Run found issues.

DEN-16637: SW: Top Alarm on Debug Screen Does Not Change When Alarm is Cleared

DEN-16640: SW: Blood Measurement Interval Set to OFF During Treatment When Set to 5 min in Pre-treatment

DEN-16641: UI: Heparin Syringe Installation Screen Missing

  1. … 4 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 612 more files in changeset.
DENBUG-207: UI: UI does not reset to default parameters upon new patient

DEN-12728: UI: UI does not clean up Treatment Parameter settings for different patient

- the reset is added to the treatment parameters

- the foundation of the pre-population has been added but still there is parts need to be added to store the sliders' On/Off switch to be restored which is needed for the slider to set properly.

  1. … 4 more files in changeset.
DEN-12728: UI: UI does not clean up Treatment Parameter settings for different patient

- the reset is added to the treatment parameters

- the foundation of the pre-population has been added but still there is parts need to be added to store the sliders' On/Off switch to be restored which is needed for the slider to set properly.

  1. … 4 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 15 more files in changeset.
DEN-15812: UI: Add an option on the Configurations setup screen to prevent the Device Registration cleanup

- Added the UI portion of the update

- Added the -U cmd-line option to get UI Application in update mode.

  1. … 12 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 73 more files in changeset.
Merge branch 'DEN-15279-UI-BN-S97-Cybersecurity' into staging

  1. … 115 more files in changeset.
DEN-15296 : Implemented the screen base and navigation of the denali -E

  1. … 23 more files in changeset.
DEN-14955 Quick Start : MainTreatment - Cleaned up RangeRect, etc to not have rounding property per design update - Update treatment duration screen per Behrouz's request to center slider arrows on confirm button - Updated ultraFiltration screens to have slider arrows

  1. … 18 more files in changeset.
DEN-14955 : Quick Start - Main treatment Screens - Update screens to appropriately use or not use rounded sliders

  1. … 18 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 11 more files in changeset.
Merge branch 'DEN-14909-UI-VD-S92-QS-Sliders' into staging

  1. … 6 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 15 more files in changeset.
DEN-14858 : UI should navigate to Standby screen on Fault state

  1. … 3 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 50 more files in changeset.
Merge branch 'DEN-14733-UI-BN-S90-2' into staging

  1. … 43 more files in changeset.
DEN-14736 : IMP: Dry-Demo Support

- added the CLI switch -D : --enable-dry-demo

- added the CLI switch -A : --active-can-bus <CANBus>

- added the CLI switch -F : --disable-fault-screen

- will send confirmation response with ConfirmationID of 99 and as accepted(1):

- e.g. 03:32:29.560,bb00,UI,Confirm,99,1

  1. … 11 more files in changeset.