Controllers

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14307 updated the concentrate pumps park command

  1. … 1 more file in changeset.
DEN-14307 added a command to be able to start and stop heat disinfect active cool mode. Added a monitor function to check the status of the caps during the heat disinfect active cool mode. Updated heating code to use TD2 temperature sensor to set the primary heater's target for the later DVT devices

  1. … 10 more files in changeset.
DEN-14307: Added support for parking concentrate pumps.

  1. … 12 more files in changeset.
DEN-14307 updated the cleaning modes per the SRS changes

  1. … 7 more files in changeset.
Merge branch 'DEN-14433-sw-s86-mg-publish-fixes' into develop

DEN-14433: DIAL-123: fixed broadcast messages to send if we are >= of their respective intervals instead of >.

Merge branch 'DEN-13050-vpi-does-not-close-after-sample-water-returns-to-flush-idle' into develop

DEN-13757 - Remove unused function monitorLoadCellsWeightOutOfRange/

DEN-13757 - Correction to load cell alarm.

DEN-13757 - All 4 load cells have a single persistent alarm. Change to correspond to how pressure alarms are handled.

  1. … 1 more file in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 1 more file in changeset.
DEN-14253 addressed the code review comments

Merged DEN-14253

  1. … 7 more files in changeset.
DEN-14253 updated the code so the trimmer heater with no flow uses the raw dialysate flow prior to applying the calibration to it.

  1. … 1 more file in changeset.
DEN-14403-dg-voltages-alarm-77-not-triggered FPGA 1V alarm limits modified to +/-5% from +/-10%, to match requirements

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14356 addressed the code review comment

DEN-14536 updated the minimum acceptable inlet pressure

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 11 more files in changeset.
DEN-14197: Code review changes. Pre-merge fixes.

  1. … 2 more files in changeset.
Merge branch 'staging' into DEN-14197-sw-s83-mg-pi-optimizations

  1. … 5 more files in changeset.
DEN-14197: Addressed code review comments.

DEN-14197: Addressed code review comments.

DEN-14197: Addressed code review comments.

  1. … 1 more file in changeset.
DEN-14197: Addressed code review comments.

  1. … 3 more files in changeset.
Merge branch 'DEN-14197-sw-s83-mg-pi-optimizations' into develop

DEN-14197: Created a set pwm step limit for PI controllers. Updated RO pump profiles to contain a max set step limit. Removed unused #defines for ro pump.

  1. … 2 more files in changeset.
DEN-14197: Created a set pwm step limit for PI controllers. Updated RO pump profiles to contain a max set step limit. Removed unused defines for ro pump.

  1. … 2 more files in changeset.
Merged DEN-14307

DEN-14307 updated the code and updated the checkAlarms.sh to check the alarms manual table upon compilation

  1. … 2 more files in changeset.