Controllers

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-9480 tested RTC stop clock and drain mode

  1. … 1 more file in changeset.
DEN-9906 Added new alarm ID for dialysate flow out of range

DEN-9906 Added new alarm ID for dialysate flow out of range

DEN-9480, DEN-10788 continued working on the heaters control and added code to be able override the drain pump RPM once the pump is in the open loop mode

  1. … 13 more files in changeset.
DEN-9480 added trimmer heater states and implemented the primary heater's efficiency code

  1. … 5 more files in changeset.
Merged DEN-9480

  1. … 5 more files in changeset.
Fixed merge conflict

  1. … 7 more files in changeset.
DEN-9480, DEN-10409 addressed the DG fault and removed the extra flow sensor check'

  1. … 5 more files in changeset.
Merged DEN-9480 and resolved the merge conflicts

  1. … 10 more files in changeset.
DEN-9480 removed the small k factor conversion of the Ro pump

  1. … 6 more files in changeset.
DEN-10410, DEN-10648 addressed events feature's issues

  1. … 5 more files in changeset.
DEN-9966: Resolved peer code review comments and added functions to handle sensor override reset

  1. … 7 more files in changeset.
DEN-9906: Misc code cleanup on new dialysate flow module.

DEN-9906: Use trimmer heater stop command enum for response.

  1. … 2 more files in changeset.
DEN-9906: Added dialysate flow sensor modules

    • -0
    • +270
    ./DialysateFlow.c
DEN-9906: Added new dialysate flow modules and implemented the code to integrate the sensor to the FPGA

  1. … 6 more files in changeset.
Added a build switch to disbale trimmer heater

  1. … 1 more file in changeset.
DEN-9480 worked on the heaters

  1. … 2 more files in changeset.
Disabled trimmer heater error

  1. … 1 more file in changeset.
Merged DEN-9480 and addressed DEN-10410

  1. … 6 more files in changeset.
DEN-9480 added events to the firmware

  1. … 12 more files in changeset.
Fixed tare load cells function

  1. … 1 more file in changeset.
Enabled the heating dialysate ignore build switch

  1. … 1 more file in changeset.
Fixed merge conflicts. Fixed DEN-10590.

DEN-9906: Fixed load cell override vs. calibration issue.

Merged DEN-9480 and resolved the conflicts

  1. … 3 more files in changeset.
DEN-9480 added a build switch to be able to use the smaller or the normal flow sensors K factor

  1. … 3 more files in changeset.
DEN-9480 removed a bypass in POST to continuously go through the UV reactors POST

  1. … 2 more files in changeset.
Merge branch 'DEN-9480-dialysate-temperature-control' into develop

DEN-10521 fixed the load cells override issue