SystemCommMessages.c

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Is this a placeholder? Should have a "TODO" comment for the planned updates. Are the flow profiles intended to change eventually? Do some of these states have different pump load conditions? Test/t...

Is this a placeholder? Should have a "TODO" comment for the planned updates. Are the flow profiles intended to change eventually? Do some of these states have different pump load conditions? Test/tuning plans? Where will setROPIFlowProfile() be called? etc.

DG-DEN-14197_SW S83 MG PI Optimizations
DG-DEN-14197_SW S83 MG PI Optimizations
DG-DEN-14316_Chemical Disinfect
DG-DEN-14316_Chemical Disinfect
DG-DEN-14307_DG HD Dev HD DG Dvt Update Part 6
DG-DEN-14307_DG HD Dev HD DG Dvt Update Part 6
RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Done.

Done.

Done.

Done.

Isn't fpgaSensorReadings an input?

Isn't fpgaSensorReadings an input?

Restore or remove.

Restore or remove.

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

This is done to get an average of the fill temperature as well as the last fill temperature prior to tranistioning to Gen Idle. These values are used for the next estimation and are different from ...

This is done to get an average of the fill temperature as well as the last fill temperature prior to tranistioning to Gen Idle. These values are used for the next estimation and are different from the heaters driver.

Done.

Done.

No, it should be removed.

No, it should be removed.

Where is valveSensedStates being updated?

Where is valveSensedStates being updated?

Remove comment.

Remove comment.

Not clear this needs to be done. I believe is properly handled in heaters when you get a temperature value and configured for V3.

Not clear this needs to be done. I believe is properly handled in heaters when you get a temperature value and configured for V3.

DG-DEN-14175_DG HD Dev HD DG Dvt Update Part 5
DG-DEN-14175_DG HD Dev HD DG Dvt Update Part 5
DG-DEN-14166_DG HD Dev HD DG Dvt Update Part 4
DG-DEN-14166_DG HD Dev HD DG Dvt Update Part 4
RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Done.

Done.