firmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DEN-15973-alarm-48-uf-rate-tare-error-triggered-during-treatment' into develop

Corrected

Corrected

DEN-15973 Code review changes

Done.

Done.

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

Corrected spacing in the file per CR comments

DEN-15973 Code review changes

Add blank line between this code and switch below.

Add blank line between this code and switch below.

Keep declarations at top of scope. Just have assignments down here.

Keep declarations at top of scope. Just have assignments down here.

DEN-15973 Remove unnecessary code per recent change.

DEN-15973 Change alarm 152 limits

DEN-15973 Surender changes.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge remote-tracking branch 'origin/DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low' into develop

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

Follow up for changes, simplifications suggested by Sean.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-16383 updated the code

These fields have been moved to a different broadcast at some point, and were no longer being set by the reservoir data broadcast. The fields regularly contained "NAN" values, so I removed them.

These fields have been moved to a different broadcast at some point, and were no longer being set by the reservoir data broadcast. The fields regularly contained "NAN" values, so I removed them.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

DEN-16383 updated mode flush

Why are these fields removed?

Why are these fields removed?

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DEN-16383 fixed the heat disinfect alarm 242 trigger

DG-DEN-16383_Heat Disinfect R1 TO R2 Timer Overflows And Stuck IN State
DG-DEN-16383_Heat Disinfect R1 TO R2 Timer Overflows And Stuck IN State
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge remote-tracking branch 'origin/DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low' into develop