firmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-15973 addressed the code review comments

DEN-15973 addressed the code review comments

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-15973 updated the code

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DEN-15973 changed the minimum inlet pressure to be a variable based on the maximum inlet water pressure set

DEN-15973 fixed the inlet water pressure alarm. DEN-16418 added chemical flush done after chemical disinfect prior to starting RO permeate sample mode

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DEN-15973 added the inlet water pressure limit in flush drain in the cleaning modes

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge remote-tracking branch 'origin/DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low' into develop

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

On Dara's advice, ifdef'ed code for fill state treatment recovery

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DEN-15973

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DIAL-283-no-moving-average-commands-conductivity' into develop

    • -0
    • +31
    ./App/Services/SystemCommMessages.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

Correcting issue with develop RESERVOIR_DATA_T

Merge remote-tracking branch 'origin/DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low' into develop

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

Reset timers when doing a test recover state, or returning from a (reset) fault condition.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DIAL-283: compiler fixes.

DIAL-283: message handling for moving average override.

    • -10
    • +7
    ./App/Modes/ModeChemicalDisinfect.c
    • -0
    • +31
    ./App/Services/SystemCommMessages.c
DIAL-283: chem disinfect moving average override

    • -6
    • +62
    ./App/Modes/ModeChemicalDisinfect.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge remote-tracking branch 'origin/DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low' into develop