Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Merge branch 'DEN-13712-dg_hd_dev-darren-sprint-77' into staging

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merge DEN-13712.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merge branch 'DEN-13801-sw_dev-sprint-79_mg' into develop

DEN-13801: Further merge fixes.

DEN-13460: Removed alarm 220 (battery charge low). Added battery remaining capacity monitor - use for blocking treatment start if < 10 min. For now, comment out blocking treatment, as most battery reads appear to not be working.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merge branch 'DEN-13801-sw_dev-sprint-79_mg' into develop

DEN-13801: fixes for merge conflict

DEN-13801: DEN-13426: wrapped a new minimum occlusion sensor count behind the V3 SWConfig.

DEN-13460 added PiSquare VectorCAST

DEN-13801: updated pressure values for Dry Self Test for both arterial and venous that are achievable within the time frame that blood pump runs.

DEN-13801: Decay State of Dry Self Tests now updates the peak pressure value after pump has stopped due to filter lag.

DEN-13598 updated the code

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-13427: post merge changes for staging

DEN-13598 Update code for new SRS with alarms.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-13834 updated the blood leak self test status set

Merge branch 'staging' into DEN-13427-sw_dev-sprint-75_mg

    • -103
    • +135
    ./Services/SystemCommMessages.c
DEN-13427: Addressed code review comments

DEN-13598 Update code for new SRS with alarms.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merged DEN-13834

DEN-13834 added the DG heaters broadcast message. Addded a function to check the status of the trimmer heater's state in DGInterface and keep sending the command from HD until the trimmer heater is in the right status. Enabled stop/start trimmer command in the modes

DEN-13460 addressed the code review comments

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo