firmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Merge branch 'DEN-11114-dg_dev-dg-dialysate-temperature-control-2-of-2' of ssh://dvm-linux02:7999/hd/hdfirmware into DEN-11114-dg_dev-dg-dialysate-temperature-control-2-of-2

DEN-11114 initial commit of the reservoirs module. Continued with implementing the reservoir management

    • -19
    • +120
    ./App/Controllers/DGInterface.c
    • -0
    • +407
    ./App/Services/Reservoirs.c
    • -0
    • +38
    ./App/Services/Reservoirs.h
DEN-11114: Updated UF control to included estimated UF flow as input.

    • -40
    • +106
    ./App/Controllers/DialOutFlow.c
DEN-11089 Incorporated peer review comments

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merge branch 'DEN-11114-dg_dev-dg-dialysate-temperature-control-2-of-2' into develop

DEN-11114: Restored previous motor controller speed feedback conversion to RPM - it was right before.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merge branch 'DEN-11114-dg_dev-dg-dialysate-temperature-control-2-of-2' into develop

DEN-11114: Fixed conversion issue for pump speed ADC voltage levels.

DEN-11114: Changed syringe ID measurement to median between min and max ID given by manufacturer. Included prime volume in calculation of volume needed to meet needs of treatment.

DEN-11089 if priming for the 1st time, transition to the HD_PRIME_SALINE_SETUP_STATE

DEN-11089 In hadlePrimeDialysateBypassState, state should be HD_PRIME_RESERVOIR_ONE_FILL_COMPLETE_STATE

DEN-11089 Swapped the dialysate priming circuit - prime the R2 circuit first then prime the R1 circuit

DEN-11089 Implemented new saline dialyzer priming state to purge air from the dialyzer path

DEN-11114: Updated syringe inner diameter to improve dispense accuracy. Updated minimum dispense rate to 0.2 mL/hr.

DEN-11114: Add 5 sec persistence to blood leak alarm. Make insufficient Heparin volume alarm pre-emptive during seek operation.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Turned off worn cartridge build switch for BP flow estimation testing.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Merge branch 'DEN-11114-dg_dev-dg-dialysate-temperature-control-2-of-2' into develop

DEN-11114: Reset BP rotor count before each treatment starts. Allow BP rotor count override to work even if WORN_CARTRIDGE build flag is enabled.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Disabled watchdog and safety shutdown POST tests for unit 2.

    • -7
    • +15
    ./App/Services/SystemCommMessages.c
DEN-11114: Added build switch to disable watchdog and safety shutdown POST tests.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 57 more files in changeset.
DEN-9906: Addressed code review feedback.

DEN-9906: Fixed doxygen comments in BloodFlow module.

DEN-9906 updated the code to support events

  1. … 4 more files in changeset.