Controllers

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-13154: Added raw flow rates to DG flow broadcast messages.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 5 more files in changeset.
DEN-14834 updated the code to just send the heater command in Idle and Drain if the primary heater is not on. Addressed the code review comments

  1. … 4 more files in changeset.
Merge branch 'staging' into DEN-14834-ro-flow-drops-to-zero-and-cp-measured-speed-1500-temporarily-during-pre-treatment

DEN-14834 updated that get target primary heater function to accomodate the changes from pre-treatment. Removed the range check from the drain pump measured RPM

  1. … 2 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 1 more file in changeset.
DEN-14788: code review comments

DEN-14834 updated the code to not check the rejection ratio and CPo if the target fill is less than 550 mL. Updated the heaters code to make sure the stop heaters command stops the heaters unless a new start command is issued

  1. … 1 more file in changeset.
DEN-14689: message naming synchronization.

  1. … 4 more files in changeset.
DEN-14788: Fixed heaters duty cycle override to immediately set PWM instead of waiting for control state machine to set PWM.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14789: Increased CP measured speed persistence to 6s in order to handle pump parking

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'DEN-14781-alarm-117-dg-can-message-not-acked' into staging

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 5 more files in changeset.
DEN-14649: Fixed park fault to consider override

DEN-14649: fixed conc pump park faults to no longer use measured speed.

DEN-14781 changed the drain pump flow control interval and the trimmer heaters minimum flow rate

DEN-14781 updated the code to be able to support Nelson modes

  1. … 4 more files in changeset.
DEN-14781 updated Nelson support

  1. … 2 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 3 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14760 changed the minimum dialysate flow rate of the trimmer heater to alarm.

DEN-14589: Implemented concentrate pump fault persistence timer.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 1 more file in changeset.
DEN-13972 added a #define for the delta temperature in the heaters

DEN-13972 changed the code in the heaters to consider if the temperatures are negative and therefore the duty cycle is not set to positive artificially

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 10 more files in changeset.
DEN-14604 added VectorCAST from PiSquare and addressed code review comments

  1. … 2 more files in changeset.