Index: firmware/App/Modes/ModeGenIdle.c
===================================================================
diff -u -r94a190522ce398399c7b93c59f788d7666ec0060 -r353d01d31bc69d4d1901ff09097ee610bb1c9dbc
--- firmware/App/Modes/ModeGenIdle.c	(.../ModeGenIdle.c)	(revision 94a190522ce398399c7b93c59f788d7666ec0060)
+++ firmware/App/Modes/ModeGenIdle.c	(.../ModeGenIdle.c)	(revision 353d01d31bc69d4d1901ff09097ee610bb1c9dbc)
@@ -107,7 +107,7 @@
     // because the initial guess in the heaters driver needs the target flow to calculate
     // the new PWMs for the main and small primary heaters
 #ifndef DISABLE_FLOW_CONTROL_TREATMENT
-    setROPumpTargetFlowRate( TARGET_FLUSH_LINES_RO_FLOW_RATE_L, TARGET_RO_PRESSURE_PSI );
+    setROPumpTargetFlowRateLPM( TARGET_FLUSH_LINES_RO_FLOW_RATE_L, TARGET_RO_PRESSURE_PSI );
     setHeaterTargetTemperature( DG_PRIMARY_HEATER, 39.0 );  // TODO remove this line. It comes form HD this for testing only
     startHeater( DG_PRIMARY_HEATER );
 #endif
@@ -217,7 +217,7 @@
     if ( flushLinesVolumeL >=  getFlushLineVolume() )
     {
 #ifndef DISABLE_FLOW_CONTROL_TREATMENT
-        setROPumpTargetFlowRate( TARGET_RO_FLOW_RATE_L, TARGET_RO_PRESSURE_PSI );
+        setROPumpTargetFlowRateLPM( TARGET_RO_FLOW_RATE_L, TARGET_RO_PRESSURE_PSI );
 #endif
         result = DG_GEN_IDLE_MODE_STATE_FLUSH_WATER;
     }