Index: firmware/App/Services/Reservoirs.c
===================================================================
diff -u -re8c019d3d43b517cabfdfe75fa5d03749d036018 -r38c28a43b71d21d72906b07e9d60107b84bffb37
--- firmware/App/Services/Reservoirs.c	(.../Reservoirs.c)	(revision e8c019d3d43b517cabfdfe75fa5d03749d036018)
+++ firmware/App/Services/Reservoirs.c	(.../Reservoirs.c)	(revision 38c28a43b71d21d72906b07e9d60107b84bffb37)
@@ -99,7 +99,7 @@
 static DG_RESERVOIR_VOLUME_RECORD_T reservoirsCalRecord;                                          ///< DG reservoirs non-volatile record.
 static DG_HEATING_CAL_RECORD_T heatingConstsCalRecord;                                            ///< DG heating calibration record.
 static F32 targetFillFlowRateLPM;                                                                 ///< Target fill flow rate in L/min.
-static BOOL isThisTheFirstCycle = TRUE;                                                           ///< Boolean flag to indicate whether this is the first cycle.
+static BOOL isThisTheFirstCycle;                                                                  ///< Boolean flag to indicate whether this is the first cycle.
 static RESERVOIRS_PREVIOUS_STATUS reservoirPreviousStatus[ NUM_OF_DG_RESERVOIRS ];                ///< Reservoirs previous status.
 
 /*********************************************************************//**
@@ -147,8 +147,7 @@
     // publish active reservoir, fill/drain volume targets at 1 Hz.
     if ( ++dataPublishCounter >= RESERVOIR_DATA_PUB_INTERVAL )
     {
-        RESERVOIR_DATA_T data;
-
+        RESERVOIR_DATA_T data;
         data.activeReservoir            = getU32OverrideValue( &activeReservoir );
         data.fillToVolumeMl             = getU32OverrideValue( &fillVolumeTargetMl );
         data.drainToVolumeMl            = getU32OverrideValue( &drainVolumeTargetMl );
@@ -209,9 +208,8 @@
 void setActiveReservoirCmd( DG_RESERVOIR_ID_T resID )
 {
     DG_CMD_RESPONSE_T cmdResponse;
-
-    cmdResponse.commandID = DG_CMD_SWITCH_RESERVOIR;
-    cmdResponse.rejected = TRUE;
+    cmdResponse.commandID  = DG_CMD_SWITCH_RESERVOIR;
+    cmdResponse.rejected   = TRUE;
     cmdResponse.rejectCode = DG_CMD_REQUEST_REJECT_REASON_NONE;
 
     // switch reservoir command only valid in generation idle mode