Index: firmware/App/HDCommon.h
===================================================================
diff -u -rd9d085cdca67200ecddbdfbc75c489e704b23081 -r61153247029a9a246ca1beadc66d772e3e583e4e
--- firmware/App/HDCommon.h	(.../HDCommon.h)	(revision d9d085cdca67200ecddbdfbc75c489e704b23081)
+++ firmware/App/HDCommon.h	(.../HDCommon.h)	(revision 61153247029a9a246ca1beadc66d772e3e583e4e)
@@ -30,10 +30,10 @@
 // ********** development build switches **********
 
 #ifndef _RELEASE_
-//#define UF_TEST_ENABLED                     1           // ultrafiltration test build (hard codes treatment params, re-purposes off/stop buttons)
+#define UF_TEST_ENABLED                     1           // ultrafiltration test build (hard codes treatment params, re-purposes off/stop buttons)
 //#define UF_TEST_WITH_DG                     1           // ultrafiltration test build (sets up DG in standby mode)
 #ifndef _VECTORCAST_
-//    #define DISABLE_UI_TREATMENT_WORKFLOW   1           // disable UI treatment workflow
+    #define DISABLE_UI_TREATMENT_WORKFLOW   1           // disable UI treatment workflow
 //    #define RM46_EVAL_BOARD_TARGET          1           // limited build runs on RM46 eval board
 //    #define BREADBOARD_TARGET               1           // old breadboard system build - no longer used?
 //    #define SIMULATE_UI                     1           // build w/o requirement that UI be there
@@ -50,11 +50,11 @@
     #define DISABLE_PUMP_DIRECTION_CHECKS   1           // do not error on HD pump direction checks
     #define DISABLE_PRESSURE_CHECKS         1           // do not error on HD pressure checks
     #define DISABLE_UF_ALARMS               1           // do not error on HD ultrafiltration checks
-    #define RUN_PUMPS_OPEN_LOOP             1           // BP and DPi pumps will be run open loop (no flow sensor feedback)
+//    #define RUN_PUMPS_OPEN_LOOP             1           // BP and DPi pumps will be run open loop (no flow sensor feedback)
 //    #define RAW_FLOW_SENSOR_DATA            1           // test build will not filter flow sensor data
 //    #define READ_FPGA_ASYNC_DATA            1           // test build reads non-priority register page every other time
 //    #define FLOW_DEBUG                      1           // test build sends flow, signal strength, and occlusion readings to debug UART
-//    #define EMC_TEST_BUILD                  1           // EMC test build - HD/DG run separately but connected, HD pumps toggle on/off w/ stop button
+    #define EMC_TEST_BUILD                  1           // EMC test build - HD/DG run separately but connected, HD pumps toggle on/off w/ stop button
     #define ALARMS_DEBUG                    1           // triggered alarms sent to debug UART
 
     #include <stdio.h>