Index: firmware/App/Modes/Rinseback.c
===================================================================
diff -u -rfc923bac57545b5794893c47a97770d8d7cfcee4 -r7e0d7c16341ea0ccd9b806a2db97553498d10365
--- firmware/App/Modes/Rinseback.c	(.../Rinseback.c)	(revision fc923bac57545b5794893c47a97770d8d7cfcee4)
+++ firmware/App/Modes/Rinseback.c	(.../Rinseback.c)	(revision 7e0d7c16341ea0ccd9b806a2db97553498d10365)
@@ -227,6 +227,21 @@
     setBloodPumpTargetFlowRate( rate, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_CLOSED_LOOP );
     // Start air trap leveling control
     startAirTrapControl();
+
+    // If DG restarted for some reason, lets make sure we set the heating parameters first before commanding to
+    // turn on the trimmer heater and start the DG as well.
+    if ( DG_MODE_STAN == getDGOpMode() )
+    {
+        F32 targetTempC       = getTreatmentParameterF32( TREATMENT_PARAM_DIALYSATE_TEMPERATURE );
+        U32 dialysateFlowMLPM = getTreatmentParameterU32( TREATMENT_PARAM_DIALYSATE_FLOW );
+
+        // Set the heating parameters
+        setPreTreatmentHeatingParams( targetTempC, DEFAULT_FILL_RESERVOIR_TO_VOLUME_ML, DEFAULT_TARGET_FILL_FLOW_RATE_LPM, dialysateFlowMLPM );
+
+        // Start the DG
+        cmdStartDG();
+    }
+
     // Re-circulate dialysate side of dialyzer w/ heating to maintain temperature
     setDialInPumpTargetFlowRate( DIALYSATE_FLOW_RATE_FOR_RECIRC, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_CLOSED_LOOP );
     cmdStartDGTrimmerHeater();