Index: configurations/Alarms/Alarms.conf
===================================================================
diff -u -rec55a70045556e618cb27526754a010147b21106 -r9851e65ac25088cce280989d0b95a78101834f46
--- configurations/Alarms/Alarms.conf	(.../Alarms.conf)	(revision ec55a70045556e618cb27526754a010147b21106)
+++ configurations/Alarms/Alarms.conf	(.../Alarms.conf)	(revision 9851e65ac25088cce280989d0b95a78101834f46)
@@ -374,19 +374,19 @@
 Message   = DD Fault: Pump Speed Fault
 
 [75]
-Title     = Incoming Water Pressure Input High
-ListTitle = DD inlet water pressure input is too high
-Message   = DD: Inlet Water Pres Input High
+Title     = Service Required: Dialysate Device
+ListTitle = DD Spent chamber fill state 1 start pressure is not in range
+Message   = DD Fault: BC Pressure not in range
 
 [76]
-Title     = Incoming Water Pressure Output Low
-ListTitle = DD Inlet water pressure output too low
-Message   = DD: Inlet Water Pres Output Low
+Title     = Service Required: Dialysate Device
+ListTitle = DD Spent chamber fill state 2 start pressure is not in range
+Message   = DD Fault: BC Pressure not in range
 
 [77]
-Title     = Incoming Water Pressure Output High
-ListTitle = DD inlet water pressure output is too high
-Message   = DD: Inlet Water Pres Output High
+Title     = Service Required: Dialysate Device
+ListTitle = DD Spent chamber fill timeout error
+Message   = DD Spent Chamber fill timeout Error
 
 [78]
 Title     = Blood Pump Stopped: Venous Air Detector
@@ -459,9 +459,9 @@
 Message   = DD Fault: Hyd Cham Neg Pres not in range
 
 [92]
-Title     = 
-ListTitle = 
-Message   = 
+Title     = Service Required: Dialysate Device
+ListTitle = DD Bicarb chamber fill timeout error
+Message   = DD Bicarb Chamber fill timeout Error
 
 [93]
 Title     = 
@@ -773,3 +773,33 @@
 ListTitle = DD dialysate temperature sensors drift timeout.
 Message   = DD Fault: D28 and D30 Delta
 
+[155]
+Title     = Blood Leak
+ListTitle = DD blood leak detected alarm
+Message   = Blood Stop: Dialyzer Blood Leak
+
+[156]
+Title     = Service Required: Hemodialysis Device
+ListTitle = DD blood leak sensor invalid calibration record
+Message   = DD POST: BLD Cal
+
+[157]
+Title     = Service Required: Hemodialysis Device
+ListTitle = DD blood leak sensor embedded mode communication failed
+Message   = DD POST: BLD Config Emb Mode
+
+[158]
+Title     = Service Required: Hemodialysis Device
+ListTitle = DD blood leak sensor set point set failure
+Message   = DD POST: BLD Config Set Point
+
+[159]
+Title     = Blood Leak: Bypass
+ListTitle = DD blood leak detected and it is in the process of attempting to remove the bubbles/foam
+Message   = Blood Stop: Dialyzer Blood Leak Bypass
+
+[160]
+Title     = FP: Permeate Underfill
+ListTitle = FP tank level is too low
+Message   = FP Tank: Tank is not filling
+