[0]
Title   = Ñsed when there is no rejection

[1]
Title   = Ñequest is not allowed in the current operating mode

[2]
Title   = Ñalidated request was not confirmed by user in reasonable time

[3]
Title   = Ñequest is not allowed if not in treatment mode

[4]
Title   = Ñequest is not allowed in current treatment state

[5]
Title   = Ñequest is not allowed so near end of treatment

[6]
Title   = Ñreatment duration is out of range

[7]
Title   = Ñreatment time change is less than currently elapsed treatment time

[8]
Title   = Ñlood flow is out of range

[9]
Title   = Ñialysate flow is out of range

[10]
Title   = Ñialysate flow rate or treatment duration causes dialysate volume to exceed limit

[11]
Title   = Ñltrafiltration volume is out of range

[12]
Title   = Ñltrafiltration rate is out of range

[13]
Title   = Ñreatment time change is less than minimum treatment time

[14]
Title   = Ñltrafiltration is not currently in progress

[15]
Title   = Ñltrafiltration is not currently paused

[16]
Title   = Ñ saline bolus is in progress

[17]
Title   = Ñ treatment parameter is out of range

[18]
Title   = Ñhe Heparin pre-stop setting is greater than the treatment duration

[19]
Title   = ÑG filter flush time has been expired

[20]
Title   = Ñot used

[21]
Title   = Ñaline bolus volume maximum has been reached - no more saline allowed

[22]
Title   = Ñ saline bolus is not in progress

[23]
Title   = Ñequested user action is disabled in current state

[24]
Title   = Ñequested user action not allowed while alarm is active

[25]
Title   = Ñequested user action invalid

[26]
Title   = Ñhe treatment has been completed

[27]
Title   = Ñinseback additional volume maximum has been reached - no more additional rinsebacks allowed

[28]
Title   = Ñialyzer not inverted yet

[29]
Title   = Ñhe user has not confirmed patient connection

[30]
Title   = Ñeparin cannot be paused if not currently deliverying Heparin

[31]
Title   = Ñeparin cannot be resumed if not paused

[32]
Title   = Ñreatment cannot initiate if DG comm is lost

[33]
Title   = Ñost-treatment reservoirs drain not complete

[34]
Title   = Ñreatment cannot initiate if DG is not in standby idle state

[35]
Title   = Ñequest message not formatted properly

[36]
Title   = Ñiven date/time is invalid

[37]
Title   = Ñreatment is in progress

[38]
Title   = Ñattery does not have enough charge to start treatment

[39]
Title   = Ñannot move on to recirculate without completing full rinseback.

[40]
Title   = Ñeservoir one fill is not complete

[41]
Title   = Ñump track is not ready / closed

[42]
Title   = Ñoor is not closed

[43]
Title   = Ñyringe is not present

[44]
Title   = Ñialysate cap open

[45]
Title   = Ñoncentrate cap open

[46]
Title   = ÑG disinfect has been expired

[47]
Title   = ÑG service is due

[48]
Title   = ÑD service is due

[49]
Title   = ÑG chemical flush is not complete

[50]
Title   = ÑG RO filter temperature out of range

[51]
Title   = ÑG firmware version is not compatible with HD firmware

[52]
Title   = Ñeparin settings are zero but pre-stop setting is non-zero

[53]
Title   = Ñaline bolus is not allowed during dialyzer reprime

[54]
Title   = ÑG RO only mode DG is busy

[55]
Title   = ÑG RO only mode invalid parameter

[56]
Title   = ÑG RO only mode invalid payload length

[57]
Title   = Ñannot resume treatment per alarm

[58]
Title   = Ñannot continue due to maximum heparin volume

[59]
Title   = Ñannot start chemical disinfect because it is not enabled in institutional record.