Index: firmware/App/Modes/FPModes/ModePreGenPermeate.c
===================================================================
diff -u -r5514c6bf48facd532e58b0790d9f02aaa6776b28 -r708e22d3862fe0efb7e864697d10b5c5d023780e
--- firmware/App/Modes/FPModes/ModePreGenPermeate.c	(.../ModePreGenPermeate.c)	(revision 5514c6bf48facd532e58b0790d9f02aaa6776b28)
+++ firmware/App/Modes/FPModes/ModePreGenPermeate.c	(.../ModePreGenPermeate.c)	(revision 708e22d3862fe0efb7e864697d10b5c5d023780e)
@@ -345,35 +345,35 @@
     FP_PRE_GENP_MODE_STATE_T state = FP_PRE_GENP_VERIFY_WATER;
     F32 roCurrentDutyCycle = getCurrentROPumpDutyCyclePCT();
 
-    checkROInletPressure();
+    //checkROInletPressure();
 
     //Stay in this state for 25 seconds to stablize flow control
     if ( TRUE == didTimeout( verifyWaterTimer, FLOW_CONTROL_STABLIZED_TIMEOUT_MS ) )
     {
         // check next 5 seconds for water quality
         // check permeate high flow rate is within range
-        checkPermeateHighFlow();
+        //checkPermeateHighFlow();
 
         // check low flow rate is within range
-        checkPermeateLowFlow();
+        //checkPermeateLowFlow();
 
         // check inlet conductivity is within range
-        checkInletConductivity();
+        //checkInletConductivity();
 
         // check permeate conductivity is within range
-        checkOutletConductivity();
+        //checkOutletConductivity();
 
         // check RO duty cycle in range
         checkRODutyCycle();
 
         // check p21 is set to 15 PSI
-        checkPressureRelief();
+        //checkPressureRelief();
 
         // check RO rejection ratio
-        checkRORejectionRatio();
+        //checkRORejectionRatio();
 
         // check RO pressure (p13)
-        checkROPressures();
+        //checkROPressures();
     }
 
 //    if ( TRUE == 1 ))// TODO Alarm and Stop State Rework