Index: firmware/App/Controllers/Heaters.c
===================================================================
diff -u -r09583a9e0a51bb47dd04c825cd706f5a3774bded -r739fdfd941e5d4dc52ca3b9916aabb8ef2d2ad45
--- firmware/App/Controllers/Heaters.c	(.../Heaters.c)	(revision 09583a9e0a51bb47dd04c825cd706f5a3774bded)
+++ firmware/App/Controllers/Heaters.c	(.../Heaters.c)	(revision 739fdfd941e5d4dc52ca3b9916aabb8ef2d2ad45)
@@ -52,7 +52,7 @@
 #define HEATERS_DUTY_CYCLE_CONVERSION_FACTOR                       100.0F                                                          ///< Heaters duty cycle 0: OFF, 100: 100% duty cycle.
 #define HEATERS_ZERO_EFFICIENCY                                    0.0F                                                            ///< Zero heater efficiency
 #define HEATER_CNTL_TRANSFER_DELTA_TEMP_C                          0.50F                                                           ///< AC heater delta temperature to transfer control from open to close loop
-#define MAX_ADJ_DELTA_TEMP_C                                       2.0F                                                            ///< Maximum adjusted delta temperature to add/remove from calculated target temperature
+#define MAX_ADJ_DELTA_TEMP_C                                       10.0F                                                           ///< Maximum adjusted delta temperature to add/remove from calculated target temperature
 
 #define D5_HEAT_TX_INIT_FEED_FORWARD                               0.0F                                                            ///< Initial Feed forward term for heater control
 //#define D5_HEAT_TX_P_COEFFICIENT                                   0.050F                                                          ///< P Term for AC primary heater control during treatment mode.
@@ -82,7 +82,7 @@
 #define D5_HEAT_CONTROL_INTERVAL_COUNT                             ( D5_HEAT_CONTROL_INTERVAL_MS / TASK_GENERAL_INTERVAL )         ///< Primary heater control interval count.
 #define D45_HEAT_CONTROL_INTERVAL_MS                               ( 1 * MS_PER_SECOND )                                           ///< Trimmer heater control interval in milli seconds
 #define D45_HEAT_CONTROL_INTERVAL_COUNT                            ( D45_HEAT_CONTROL_INTERVAL_MS / TASK_GENERAL_INTERVAL )        ///< Trimmer heater control interval count.
-#define D5_TARGET_TEMP_ADJUST_INTERVAL_MS                          ( 10 * SEC_PER_MIN * MS_PER_SECOND / TASK_GENERAL_INTERVAL )    ///< Adjust primary target temperature
+#define D5_TARGET_TEMP_ADJUST_INTERVAL_MS                          ( 2 * SEC_PER_MIN * MS_PER_SECOND / TASK_GENERAL_INTERVAL )    ///< Adjust primary target temperature
 #define PRIMARY_HEATER_MAX_PWR_WATTS                               1400.0F                                                         ///< AC Primary Heater Max Power consumeption in Watts
 #define TX_PRIMARY_HEATER_MAX_PWR_WATTS                            700.0F                                                          ///< Estimated power to be supplied to the primary heater during treatement mode
 #define HEAT_PRIMARY_HEATER_MAX_PWR_WATTS                          980.0F                                                          ///< Estimated power to be supplied to the primary heater during heat disinfect mode