Index: firmware/App/Modes/ModeGenIdle.c
===================================================================
diff -u -r7577b0a8157a90fe267b154e320877ff31574432 -r6f434374a54fb71ab32421aad2a17e9a848e0d8c
--- firmware/App/Modes/ModeGenIdle.c	(.../ModeGenIdle.c)	(revision 7577b0a8157a90fe267b154e320877ff31574432)
+++ firmware/App/Modes/ModeGenIdle.c	(.../ModeGenIdle.c)	(revision 6f434374a54fb71ab32421aad2a17e9a848e0d8c)
@@ -47,7 +47,7 @@
 
 #define TARGET_RO_PRESSURE_PSI                  130                                            ///< Target pressure for RO pump.
 #define TARGET_RO_FLOW_RATE_L                   0.8F                                           ///< Target flow rate for RO pump.
-#define MAX_IDLE_RSVR_WEIGHT_GAIN               200.0F                                         ///< Maximum fluid gain of inactive reservoir in Gen Idle mode (mL)
+#define MAX_IDLE_RSVR_WEIGHT_GAIN_ML            200.0F                                         ///< Maximum fluid gain of inactive reservoir in Gen Idle mode (mL)
 #define HD_LOST_COMM_TIMEOUT_MS                 (5 * SEC_PER_MIN * MS_PER_SECOND )             ///< The time of HD lost comm before DG transition back to standby.
 #define BAD_FILL_SUBSTATES_PUB_INTERVAL         ( MS_PER_SECOND / TASK_GENERAL_INTERVAL )      ///< Interval (ms/task time) at which the bad fill sub-states is published on the CAN bus.
 #define DATA_PUBLISH_COUNTER_START_COUNT        61                                             ///< Data publish counter start count.
@@ -317,7 +317,7 @@
     }
 
     // Check for unwanted filling
-    if ( reservoirWeight > ( initialReservoirWeight +  MAX_IDLE_RSVR_WEIGHT_GAIN ) )
+    if ( reservoirWeight > ( initialReservoirWeight +  MAX_IDLE_RSVR_WEIGHT_GAIN_ML ) )
     {
         SET_ALARM_WITH_2_U32_DATA( ALARM_ID_DG_INACTIVE_RESERVOIR_WEIGHT_OUT_OF_RANGE, initialReservoirWeight, reservoirWeight );
     }