Index: firmware/App/HDCommon.h
===================================================================
diff -u -raa0c1b0150e1eeb2ff5f7cac8715ecacb6aca119 -r340ca3700bbc4235d85d82864597fe17ab4b557a
--- firmware/App/HDCommon.h	(.../HDCommon.h)	(revision aa0c1b0150e1eeb2ff5f7cac8715ecacb6aca119)
+++ firmware/App/HDCommon.h	(.../HDCommon.h)	(revision 340ca3700bbc4235d85d82864597fe17ab4b557a)
@@ -25,7 +25,7 @@
 #define HD_VERSION_MAJOR        0
 #define HD_VERSION_MINOR        5
 #define HD_VERSION_MICRO        0
-#define HD_VERSION_BUILD        9009
+#define HD_VERSION_BUILD        9012
 
 // ********** development build switches **********
 
@@ -34,7 +34,7 @@
 #ifndef _VECTORCAST_
 //    #define USING_DEBUGGER                  1           // Want to be able to use the debugger and have break points
 //    #define BOARD_WITH_NO_HARDWARE          1           // Target is a PCB w/ no hardware
-    #define RUN_WITHOUT_DG                  1           // Run HD w/o DG
+//    #define RUN_WITHOUT_DG                  1           // Run HD w/o DG
 //    #define SIMULATE_UI                     1           // Build w/o requirement that UI be there
 //    #define TASK_TIMING_OUTPUT_ENABLED      1           // Re-purposes alarm lamp pins for task timing
 //    #define DISABLE_ALARM_AUDIO             1           // Disable alarm audio
@@ -59,7 +59,7 @@
 //    #define RUN_PUMPS_OPEN_LOOP             1           // BP and DPi pumps will be run open loop (no flow sensor feedback)
 //    #define RAW_FLOW_SENSOR_DATA            1           // Test build will not filter flow sensor data
 //    #define READ_FPGA_ASYNC_DATA            1           // Test build reads non-priority register page every other time
-    #define EMC_TEST_BUILD                  1           // EMC test build - HD/DG run separately but connected, HD pumps toggle on/off w/ stop button
+//    #define EMC_TEST_BUILD                  1           // EMC test build - HD/DG run separately but connected, HD pumps toggle on/off w/ stop button
     #define ALARMS_DEBUG                    1           // Triggered alarms sent to debug UART
     #define SKIP_PRIMING                    1           // Skip Pre-treatment Prime
     #define SKIP_WET_SELF_TESTS             1           // Skip Pre-treatment prime wet self-tests