Index: firmware/App/Modes/BloodPrime.c
===================================================================
diff -u -rcc4f8440e8ad7fa8f2ced2467d922be7422c344c -rf416391a93d78ea154b43afd09a8764e2573fd9a
--- firmware/App/Modes/BloodPrime.c	(.../BloodPrime.c)	(revision cc4f8440e8ad7fa8f2ced2467d922be7422c344c)
+++ firmware/App/Modes/BloodPrime.c	(.../BloodPrime.c)	(revision f416391a93d78ea154b43afd09a8764e2573fd9a)
@@ -237,10 +237,14 @@
         cmdStopDGTrimmerHeater();       // Stop trimmer heater - dialysis sub-mode will restart as appropriate
     }
     // Is blood prime taking too long based on set BP rate?
-    else if ( ( fabs( expectedBloodPrimeVolume_mL - getBloodPrimeVolume() ) > MAX_BLOOD_PRIME_VOLUME_ERROR_ML ) &&
-              ( getSoftwareConfigStatus( SW_CONFIG_DISABLE_PUMP_FLOW_CHECKS ) != SW_CONFIG_ENABLE_VALUE ) )
+    else if ( fabs( expectedBloodPrimeVolume_mL - getBloodPrimeVolume() ) > MAX_BLOOD_PRIME_VOLUME_ERROR_ML )
     {
-        activateAlarmNoData( ALARM_ID_BLOOD_PRIME_VOLUME_CHECK_FAILURE );
+#ifndef _RELEASE_
+        if ( getSoftwareConfigStatus( SW_CONFIG_DISABLE_PUMP_FLOW_CHECKS ) != SW_CONFIG_ENABLE_VALUE )
+#endif
+        {
+            activateAlarmNoData( ALARM_ID_BLOOD_PRIME_VOLUME_CHECK_FAILURE );
+        }
     }
     else
     {