Index: firmware/App/Modes/BloodPrime.c
===================================================================
diff -u -rd33ae635eb38ae8f2647f68304be74e8e4f78cfd -r667feab319b14681a0330a715da7a1ba930b518d
--- firmware/App/Modes/BloodPrime.c	(.../BloodPrime.c)	(revision d33ae635eb38ae8f2647f68304be74e8e4f78cfd)
+++ firmware/App/Modes/BloodPrime.c	(.../BloodPrime.c)	(revision 667feab319b14681a0330a715da7a1ba930b518d)
@@ -235,14 +235,12 @@
         signalBloodPrimeToDialysis();   // Signal treatment mode that it's time to start dialysis
         cmdStopDGTrimmerHeater();       // Stop trimmer heater - dialysis sub-mode will restart as appropriate
     }
-#ifndef DISABLE_PUMP_FLOW_CHECKS
     // Is blood prime taking too long based on set BP rate?
     else if ( ( fabs( expectedBloodPrimeVolume_mL - getBloodPrimeVolume() ) > MAX_BLOOD_PRIME_VOLUME_ERROR_ML ) &&
               ( getSoftwareConfigStatus( SW_CONFIG_DISABLE_PUMP_FLOW_CHECKS ) != SW_CONFIG_ENABLE_VALUE ) )
     {
         activateAlarmNoData( ALARM_ID_BLOOD_PRIME_VOLUME_CHECK_FAILURE );
     }
-#endif
     else
     {
         // ramp blood pump on ramp interval