Index: firmware/App/Modes/ModePreTreat.c
===================================================================
diff -u -r9917168057bd03662f2904ea94a5e9350fafed25 -r0c47d08286884fdcb523c95e97befc5404f582d0
--- firmware/App/Modes/ModePreTreat.c	(.../ModePreTreat.c)	(revision 9917168057bd03662f2904ea94a5e9350fafed25)
+++ firmware/App/Modes/ModePreTreat.c	(.../ModePreTreat.c)	(revision 0c47d08286884fdcb523c95e97befc5404f582d0)
@@ -43,7 +43,6 @@
 
 /// Wait time for ui to transition on completion of a sub-mode (ms/task time).
 #define SUBMODE_COMPLETE_UI_TRANSITION_TIME_COUNT       ( MS_PER_SECOND / TASK_GENERAL_INTERVAL )
-/// TODO: Restore to 100 when DPi flow control is fixed.
 #define DIP_PATIENT_CONNECTION_FLOW_RATE_ML_MIN         250             ///< Patient connection sub-mode dialysate inlet pump flow rate in mL/min.
 
 #define PRE_TREATMENT_MIN_FILL_RESERVOIR_VOLUME_ML      125             ///< Fill reservoir to this volume minimum to prep volume during development.
@@ -668,8 +667,7 @@
 
     signalBloodPumpHardStop();
     signalDialOutPumpHardStop();
-    //setDialInPumpTargetFlowRate( DIP_PATIENT_CONNECTION_FLOW_RATE_ML_MIN, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP );
-    setDialInPumpTargetFlowRate( 250, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP ); // TODO remove this line once the new flow control is implemented
+    setDialInPumpTargetFlowRate( DIP_PATIENT_CONNECTION_FLOW_RATE_ML_MIN, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP );
     cmdStartDGTrimmerHeater();
 }