Index: firmware/App/Modes/ModePreTreat.c
===================================================================
diff -u -rdf4242fcc91f8cd1aada438b33fa845c223d0e0e -rf1d120886e090e82cef5b31d371db9ac294d3479
--- firmware/App/Modes/ModePreTreat.c	(.../ModePreTreat.c)	(revision df4242fcc91f8cd1aada438b33fa845c223d0e0e)
+++ firmware/App/Modes/ModePreTreat.c	(.../ModePreTreat.c)	(revision f1d120886e090e82cef5b31d371db9ac294d3479)
@@ -7,8 +7,8 @@
 *
 * @file    ModePreTreat.c
 *
-* @author  (last)      Michael Garthwaite
-* @date    (last)      24-Aug-2022
+* @author  (last)      Dara Navaei
+* @date    (last)      19-Sep-2022
 *
 * @author  (original)  Dara Navaei
 * @date    (original)  05-Nov-2019
@@ -43,9 +43,9 @@
 
 /// Wait time for ui to transition on completion of a sub-mode (ms/task time).
 #define SUBMODE_COMPLETE_UI_TRANSITION_TIME_COUNT       ( MS_PER_SECOND / TASK_GENERAL_INTERVAL )
+/// TODO: Restore to 100 when DPi flow control is fixed.
+#define DIP_PATIENT_CONNECTION_FLOW_RATE_ML_MIN         250             ///< Patient connection sub-mode dialysate inlet pump flow rate in mL/min.
 
-#define DIP_PATIENT_CONNECTION_FLOW_RATE_ML_MIN         100             ///< Patient connection sub-mode dialysate inlet pump flow rate in mL/min.
-
 #define PRE_TREATMENT_FLUSH_RESERVOIR_VOLUME_ML         500             ///< Fill reservoir to this volume (in mL) to flush filter and lines.
 #define PRE_TREATMENT_FILL_RESERVOIR_ONE_VOLUME_ML      1300            ///< Fill reservoir one to this volume (in mL) during pre-treatment mode.
 #define PRE_TREATMENT_FILL_RESERVOIR_TWO_VOLUME_ML      700             ///< Fill reservoir two to this volume (in mL) during pre-treatment mode.
@@ -598,7 +598,8 @@
 
     signalBloodPumpHardStop();
     signalDialOutPumpHardStop();
-    setDialInPumpTargetFlowRate( DIP_PATIENT_CONNECTION_FLOW_RATE_ML_MIN, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP );
+    //setDialInPumpTargetFlowRate( DIP_PATIENT_CONNECTION_FLOW_RATE_ML_MIN, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP );
+    setDialInPumpTargetFlowRate( 250, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP ); // TODO remove this line once the new flow control is implemented
     cmdStartDGTrimmerHeater();
 }