Index: firmware/App/Modes/Prime.c
===================================================================
diff -u -rf760ffc4b10556e5186e9ceb90294262063440ca -r8afac005a36a62d8d36e58a4c46d0225b3367204
--- firmware/App/Modes/Prime.c	(.../Prime.c)	(revision f760ffc4b10556e5186e9ceb90294262063440ca)
+++ firmware/App/Modes/Prime.c	(.../Prime.c)	(revision 8afac005a36a62d8d36e58a4c46d0225b3367204)
@@ -46,6 +46,7 @@
 #define BLOOD_PUMP_FAST_FLOW_RATE_CIRC_BLOOD_CIRCUIT_ML_MIN 300                                                ///< Blood pump fast flow rate during prime recirculate blood circuit state.
 #define BLOOD_PUMP_FLOW_RATE_SALINE_DIALYZER_ML_MIN         300                                                ///< Blood pump flow rate during prime the saline dialyzer dialysate state.
 #define DIALYSATE_PUMP_PRIME_FLOW_RATE_ML_MIN               300                                                ///< Dialysate pump flow rate during priming fluid path.
+#define DIALYSATE_PUMP_FAST_PRIME_FLOW_RATE_ML_MIN          600                                                ///< Dialysate pump flow rate during priming fluid path.
 #define DPO_PUMP_PRIME_FLOW_RATE_ML_MIN                     225                                                ///< Dialysate outlet pump flow rate needed to match PWM with dialysate inlet pump @ 300 mL/min in open loop mode.
 
 #define DIALYSATE_DIALYZER_TUBE_VOLUME_ML                   115                                                ///< This total tube volume is used to calculate the Dpi & Dpo time out in the dialysate dialyzer state.
@@ -877,15 +878,15 @@
     {
         DG_SWITCH_RSRVRS_CMD_T rsrvrCmd;
 
-        rsrvrCmd.reservoirID            = (U32)DG_RESERVOIR_1;
+        rsrvrCmd.reservoirID            = (U32)DG_RESERVOIR_2;
         rsrvrCmd.useLastTrimmerHeaterDC = FALSE;
 
         cmdSetDGActiveReservoir( &rsrvrCmd );
 
         if ( TRUE == hasDGCompletedReservoirSwitch() )
         {
             signalBloodPumpHardStop();
-            setDialInPumpTargetFlowRate( DIALYSATE_PUMP_PRIME_FLOW_RATE_ML_MIN, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP );
+            setDialInPumpTargetFlowRate( DIALYSATE_PUMP_FAST_PRIME_FLOW_RATE_ML_MIN, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP );
 
             setValvePosition( VDI, VALVE_POSITION_C_CLOSE );
             setValvePosition( VDO, VALVE_POSITION_C_CLOSE );