Index: firmware/App/Modes/Prime.c
===================================================================
diff -u -r69ccdb2725e7aed091392a5b7d8d59afcd7afd33 -rba5306539f60ac7d27220fdc3173a22a5368f2ff
--- firmware/App/Modes/Prime.c	(.../Prime.c)	(revision 69ccdb2725e7aed091392a5b7d8d59afcd7afd33)
+++ firmware/App/Modes/Prime.c	(.../Prime.c)	(revision ba5306539f60ac7d27220fdc3173a22a5368f2ff)
@@ -46,6 +46,7 @@
 #define BLOOD_PUMP_FAST_FLOW_RATE_CIRC_BLOOD_CIRCUIT_ML_MIN 300                                                ///< Blood pump fast flow rate during prime recirculate blood circuit state.
 #define BLOOD_PUMP_FLOW_RATE_SALINE_DIALYZER_ML_MIN         300                                                ///< Blood pump flow rate during prime the saline dialyzer dialysate state.
 #define DIALYSATE_PUMP_PRIME_FLOW_RATE_ML_MIN               300                                                ///< Dialysate pump flow rate during priming fluid path.
+#define DPO_PUMP_PRIME_FLOW_RATE_ML_MIN                     225                                                ///< Dialysate outlet pump flow rate needed to match PWM with dialysate inlet pump @ 300 mL/min in open loop mode.
 
 #define DIALYSATE_DIALYZER_TUBE_VOLUME_ML                   115                                                ///< This total tube volume is used to calculate the Dpi & Dpo time out in the dialysate dialyzer state.
 #define DIALYSATE_DIALYZER_BYPASS_TUBE_VOLUME_ML             75                                                ///< This volume is used to calculate the DPi pump time out in the dialyzer bypass state.
@@ -606,7 +607,7 @@
 
             signalBloodPumpHardStop();
             setDialInPumpTargetFlowRate( DIALYSATE_PUMP_PRIME_FLOW_RATE_ML_MIN, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP );
-            setDialOutPumpTargetRate( 225, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP ); // 225 target flow rate matches PWM duty cycle for DPi pump @ 300.
+            setDialOutPumpTargetRate( DPO_PUMP_PRIME_FLOW_RATE_ML_MIN, MOTOR_DIR_FORWARD, PUMP_CONTROL_MODE_OPEN_LOOP );
 
             // Calculate the time out value that must passed prior to checking for the steady state volume in the reservoir
             primeDialysateDialyzerTimeLimit = (U32)( ( ( DIALYSATE_DIALYZER_TUBE_VOLUME_ML + dialyzerDialysateVolume ) * SEC_PER_MIN * MS_PER_SECOND ) / DIALYSATE_PUMP_PRIME_FLOW_RATE_ML_MIN );