Index: firmware/App/Modes/Prime.c
===================================================================
diff -u -r645a316a9cda57a4d7561080add53dd12bbe4770 -rf9d86272e3f352766e48ecc71189c0b6c8106bc1
--- firmware/App/Modes/Prime.c	(.../Prime.c)	(revision 645a316a9cda57a4d7561080add53dd12bbe4770)
+++ firmware/App/Modes/Prime.c	(.../Prime.c)	(revision f9d86272e3f352766e48ecc71189c0b6c8106bc1)
@@ -39,7 +39,7 @@
 #define MAX_PRIME_TIME                                      ( 10 * SEC_PER_MIN )                        ///< Maximum prime time (in seconds).
 #define PRIME_DATA_PUB_INTERVAL                             ( MS_PER_SECOND / TASK_GENERAL_INTERVAL )   ///< Interval (ms/task time) at which the prime data is published on the CAN bus.
 
-#define BLOOD_PUMP_FAST_FLOW_RATE_PURGE_AIR_ML_MIN          400                                         ///< Blood pump fast flow rate to fill fluid.
+#define BLOOD_PUMP_FAST_FLOW_RATE_PURGE_AIR_ML_MIN          300                                         ///< Blood pump fast flow rate to fill fluid.
 #define BLOOD_PUMP_SLOW_FLOW_RATE_PURGE_AIR_ML_MIN          150                                         ///< Blood pump slow flow rate after fluid reach lower level of air trap sensor.
 #define BLOOD_PUMP_SALINE_FLOW_RATE_PURGE_AIR_ML_MIN        200                                         ///< Blood pump very slow flow rate during prime saline dialyzer state
 #define BLOOD_PUMP_FLOW_RATE_CIRC_BLOOD_CIRCUIT_ML_MIN      300                                         ///< Blood pump flow rate during prime recirculate blood circuit state.
@@ -628,10 +628,10 @@
                     }
                     else
                     {
-                        state = HD_PRIME_RESERVOIR_TWO_FILL_COMPLETE_STATE;
+                        state = HD_PRIME_SALINE_DIALYZER_SETUP_STATE;
                     }
 #else
-                    state = HD_PRIME_RESERVOIR_TWO_FILL_COMPLETE_STATE;
+                    state = HD_PRIME_SALINE_DIALYZER_SETUP_STATE;
 #endif
                 }
             }