Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-13834 added the drain pump current and direction alarms. Updated the heaters driver disinfect control. Added a check to ignore the trimmer heater stop command from HD if DG is in the heat disinfect or chemical disinfect

DEN-13834 added more self test alarms. Added FPGA functions to get the drain pump current feedbakc, speed feedback, and direction

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

updated min drain inlet psi from -3 to -6 for demo.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

updated pressure offset to reflect new calculations.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DEN-13903-s80-mg-dg-comm-buffer-opti' into develop

DEN-13903: updated pressure offset for psia conversion

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DEN-13903-s80-mg-dg-comm-buffer-opti' into develop

DEN-13903: DEN-13987: Updated dg pressure's adc to psi to reflect new calculations.

Updated Pressure adc count to psi to reflect new calculations.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DEN-13834-dg_hd_dev-hd_dg_dvt-update-part-3' into develop

DEN-13834 updated the fault mode

Alarm for invalid loadCellID?

Alarm for invalid loadCellID?

Should there be an alarm if loadCellID is invalid?

Should there be an alarm if loadCellID is invalid?

Why the change?

Why the change?

Merge branch 'DEN-13834-dg_hd_dev-hd_dg_dvt-update-part-3' of ssh://dvm-linux02:7999/dg/dgfirmware into DEN-13834-dg_hd_dev-hd_dg_dvt-update-part-3

DEN-13834: Fixed loadcell range check.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merged DEN-13834

    • -34
    • +16
    ./Controllers/ConductivitySensors.c
    • -16
    • +17
    ./Controllers/TemperatureSensors.c
  1. … 3 more files in changeset.
Merge branch 'DEN-13834-dg_hd_dev-hd_dg_dvt-update-part-3' of ssh://dvm-linux02:7999/dg/dgfirmware into DEN-13834-dg_hd_dev-hd_dg_dvt-update-part-3

DEN-13834 added self test alarms

DEN-13834: Added additional override of load cell after calibration but before filter/tare.

DEN-13834: minor change to logging data of LC drift alarm.

Do we still need this? If so, can we make a s/w config instead?

Do we still need this? If so, can we make a s/w config instead?

Is this resolved?

Is this resolved?