Modes

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Merge branch 'DEN-14170-sw_dev_sprint_82_darren' into staging

  1. … 1 more file in changeset.
Merge branch 'DEN-14170-sw_dev_sprint_82_darren' into develop

  1. … 1 more file in changeset.
DEN-14175 merged staging and resolved the conflicts

  1. … 2 more files in changeset.
DEN-14175 addressed the code review comments

Merge branch 'DEN-14150-hd-dialysate-flow-estimation' into develop

  1. … 2 more files in changeset.
DEN-14170 Updated for code review comments.

  1. … 1 more file in changeset.
DEN-14150: Address code review comments

  1. … 2 more files in changeset.
Merged DEN-14175

  1. … 6 more files in changeset.
DEN-14170 Fix TODO with new fault.

  1. … 1 more file in changeset.
DEN-14175 updated the reservoir switch command to send the trimmer use the previous duty cycle or estimate the duty cycle

  1. … 5 more files in changeset.
DEN-14175: Added f/w support for alarm dialog blood stopped countdown while in rinseback state per DEN-10791.

DEN-14175: Stop syringe pump on transition to fault mode only. Continuous stopping of pump was preventing DAC write on force sensor check failure. DEN-14254.

Merge branch 'DEN-14175-dg_hd_dev-hd_dg_dvt-update-part-5' into develop

  1. … 2 more files in changeset.
DEN-14175 implemented the FGPA hardware configuration register, changed the trimmer heater start/stop command to HD command and not the log in command. Added a command to benign the polynomial calibration values of the temperature sensors

  1. … 7 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 2 more files in changeset.
Merge branch 'DEN-13801-sw_dev-sprint-79_mg' into develop

DEN-13801: cosmetic code review changes.

DEN-13801: reverted priming changes to explicitly set active reservoir.

DEN-13801: fixed getpretreatmentfillvolume missing brackets for conditional statements.

DEN-13801: fixed rsvr mgmt causing r2 to fill to 700 instead of 1300.

DEN-13801: forced start rsvr mgmt to have res 2 as active. Changed prime max time to 30 minutes. Moved signalactiontoresumefill() to be executed when dry self tests are disabled. Fixed wet self tests stalling in state 3.

DEN-13801: removed unnecessary cmdsetactive reservoirs in reservoir management. initialized flushed status flags.

Merge branch 'DEN-14150-hd-dialysate-flow-estimation' into develop

  1. … 4 more files in changeset.
DEN-14150: Reset rotor counts when starting new treatment workflow. Added DPi rotor count override message handling.

  1. … 5 more files in changeset.
DEN-13801: added new switch reservoir request state to pretreatment reservoir management to prevent switches from failing

DEN-13801: Restored delay of pre-tx reservoir mgmt until after consumables s.t. state.

DEN-13801: Removed worn out cartridge check within execDrySelfTests.

DEN-14170 Preload syringe in PreTreat / no cartridge selftests.

  1. … 2 more files in changeset.
DEN-13801: Updated pre-tx reservoir mgmt to delay all fills until after pressure leak test, and delay that test until both reservoirs drained.

DEN-13801: Extended dry self test timeout time from 3 minutes to 12 minutes.