Yes,

In pre-treatment

Fixed

Yes, fixed

Add a command to turn air pump off here in this state (since we aren't doing that in transition anymore to prevent large pressure drop).

Don't turn off air pump here - looks like we lose too much air pressure when we do that. Move this command to the stabilize state handler (I'll add a comment there).

You removed it here, but where did it go? I expected to see it in next case below.

Align "="

Add comment to right.

I don't have a good option. If we're going to change it to pull approach later, can't we just ignore rate changes when doing fluid bolus with sub fluid until you implement the pull approach? Are we even able to do sub fluid bolus yet? Do we have HDF tube sets?

Sure

I'll implement the pull approach later, this is temporary fix.
We need to run Sub pump at Qb rate, if Qb is updated, how can we increase Qsub?

Should we check to see if blood sitting timer has not exceeded time limit before we resume (similar to what we do from rinseback stop state before we start an additional)?

So we will command BP every 50ms for saline (okay, but not the pull approach we talked about) and send DD Qsub commands every 50ms for sub fluid (probably not a good idea)?

Those transitions to send the pressure result event. That was carried over from the previous implementation. Since the state changes are already reported through the common sub-state/operation-status events, I'll remove the pressure result event from those individual transitions for consistency.

Need the TDDef.h changes that include the enum naming updates

Should reset happen when transitioning out of this state (into next state)? I think we want to allow time for pressure to stabilize while open to atmosphere after we open these valves before we reset the offsets.

Where are we transitioning to prime?

Remove blank line.

Remove blank line.

Remove blank line.

Remove blank line.

Remove blank line.

Remove blank line.

Remove extra blank line.

keep the space

How come some transitions get an event and others dont? what is the intention?

Remove extra blank line.

Remove extra blank line.

Add alarms to header.