Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-307-concentrate-pump-tube-ruptures-during-heat-disinfection-staging' into develop

DEN-17263 fixed the code to check the direction of the concentrate pumps and then decide based on that whether the measured speed values being negative or positive is correct or not

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-307-concentrate-pump-tube-ruptures-during-heat-disinfection-staging' into develop

DEN-17263 added code to check the concentrate pumps speed direction

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-307-concentrate-pump-tube-ruptures-during-heat-disinfection-staging' into develop

DENBUG-307 added code to broadcast the concentrate pumps speed the way they are regardless of the direction of the pump

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-307-concentrate-pump-tube-ruptures-during-heat-disinfection-staging' into develop

DENBUG-307 made the concentrate pumps speed check all absolute to be able to check both positive and negative targets and measured speeds

DEN-17263 change the concentrate pumps speed check to not use fabs for the measured values. The target speed is checked in fabs to cover the negative target speeds

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DENBUG-307-concentrate-pump-tube-ruptures-during-heat-disinfection-staging' into develop

DENBUG-309 added mode flush to the 5% tolerance of the concentrate pumps speed check

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merged DEBUG-307

DENBUG-304 uncommeted the code that synchronizes the DG RTC time with HD upon starting a treatment

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merged DENBUG-307

DENBUG-309 changed the concnetrate pumps speed monitor to 5% in heat disinfect

DENBUG-307 updated the heat disinfect to run the concentration pumps for the duration of heat disinfect from the time that the reservoirs are filled up until the end of disinfect R2 to R1

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DEN-17234 addressed the code review comments

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merged DEN-17234

DEN-17234 added pretreatment expedite test configuration to DG and implemented in DG fill