Update all function headers in this file to Leahi style (e.g. \b before inputs/outputs).

Add extra line (should be 2 lines) after test support banner.

Remove extra blank line.

Update function header format from Denali to Leahi style (e.g. \b for inputs/outputs) throughout this file.

currentInstallState is an input.

Do we need doxygen comments for static function declarations?
We will have a header in the definition.

AirPump.h should be above AirTrap.h

it will be adjusted when I merge latest staging

not required anymore, forgot to remove

I think a comment here is needed. Keep it and maybe mention rinseback alarm responses too.

Maybe this should be handled in OperationModes exec since it applies to all confirmations (not just alarm related ones).

There will be confirmations that are not handled here (e.g. power off). So we shouldn't fault in default - we should do nothing.

Shutdown would be handled somewhere else (buttons.c probably). It's not related to alarms.

Is this still possible since we're not returning to TxPaused from rinseback anymore?

Is rinseback completed an indication that we've done a blood prime following a temporary break?
If so, I guess this makes sense, but we have to do more than increase the UF volume. We have to adjust the UF rate so that we will reach the new (larger) UF volume when the treatment completes.
We also need to add RB volume to UF volume in pre-tx when treatment parameters are given/validated (for the final rinseback which we will always have so we should just plan for it before treatment starts).

What if multiple confirmations pending? Which ID will this function return?

Align comments.
Should substitution pump data be moved down to 0xBA instead of commented out?

Remove extra ;

Can we align comments?

Missing pinch valves (H1 and H19).

Remove this blank line.

please add message id.

We should set all TD actuators here, not just blood pump.

I think we should accept this as long as we're in pre-tx: install state. User might confirm before auto-load finishes and that's ok.

Change "SetupConnection" to "SetupTubingSetConnection"