Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14175 addressed the code review comments

DEN-14175 created a getHWConfig in FPGA

DEN-14175 merged staging

DEN-14175 uncommented the code that was commented to test heat disinfect drain/RO pumps

DEN-14175 updated the extra temperature to 0.0 from 2.0

DEN-14175 addressed the code review comments

DEN-14175 added trimmer heater use last duty cycle to the broadcast data

DEN-14175 addressed the code review comments and replaced the V3 enable software configuration flag with the hardware configuration flag from FGPA. Updated the trimmer heater's ramp state to check the use previous duty cycle flag instead of estimating the duty cycle.

DEN-14175, DEN-13999 uncommented DG pressure sensors alarm

DEN-14175, DEN-13999 updated the pressure sensors persitent alarm. Added hardware configuration functions to check the status of the device (i.e. BETA, DVT)

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14232 updated the VPo status to prevent filling the reservoirs at the end of heat disinfect

Merge branch 'staging' into DEN-14175-dg_hd_dev-hd_dg_dvt-update-part-5

DEN-14175, DIAL-213 added drain pump current and direction override commands, updated the heaters driver with the latest optimization requirements, added a DG valves sensed states override command

DEN-14232 Turn off trimmer heater before switching to FILL_R2_WITH_HOT_WATER and then back on when switching to HEAT_DISINFECT_R2_TO_R1.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'staging' into DEN-13786-hd_dg_dev-s78_bb

DEN-14175 added alarms to check the conductivity sensor's bad received hex characters

    • -15
    • +28
    ./Controllers/ConductivitySensors.c
DEN-13786 Correct VPo

DEN-13786 Correct heater PWM and proper position of VPo for Drain_R2

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-13786 Code review changes

DEN-13786 Code review changes

DEN-14166 updated the heat disinfect temperature gradient out of range

Merged staging

Merge branch 'staging' into DEN-13786-hd_dg_dev-s78_bb

# Conflicts:

# firmware/App/Controllers/DialysateFlow.c

# firmware/App/Controllers/Heaters.c

# firmware/App/Controllers/ROPump.c

# firmware/App/Controllers/UVReactors.c

# firmware/App/Modes/ModeHeatDisinfect.c

    • -186
    • +91
    ./Controllers/TemperatureSensors.c