Controllers

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DENBUG-232 fixed the tare code in the service mode

DENBUG-232 added code to apply auto cal offset in the loadcells if DG is in service mode

DENBUG-232 added code in the load cells driver to not apply the default tare values once the system is under calibration

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 3 more files in changeset.
DENBUG-236 changed the load cells code to get the tare values from cal data when available

DENBUG-232 added code to get the reservoirs empty weight from the calibration records and set the reservoirs tare offset to 0 upon transitioning to service mode

  1. … 1 more file in changeset.
DEN-16782 changed the tare to fabs

DENBUG-236 added code to set the concentrate pumps park status in progress to TRUE

DENBUG-236 added code to check the progress of the concentrate pump's park

  1. … 1 more file in changeset.
DENBUG-236 changed the code set the reset park alarms to False once the pump started and not to park the concentrate pumps if they are already parked

  1. … 1 more file in changeset.
DENBUG-236 removed the dead code

DENBUG-236 changed the concentrate pumps to park in Gen Idle and also remove the concentrate pumps park alarm

  1. … 1 more file in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DENBUG-216 added code to clear the UV reactors with no flow and UV reactors health alarms when the UV reactor is off

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 1 more file in changeset.
DEN-16782 updated the code

DEN-16782 changed the empty reservoir weight

DEN-16782 changed the code to set the tare value in the init of the load cells

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-16769 updated the VectorCAST test case for the drain pump

DEN-16769 changed the required minimum RPM for the drain pump direction check to 100 RPM

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 3 more files in changeset.
DENBUG-213 added a comment

DEN-16682 upaded the drivers to get the calibration values once the signal is emitted. DENBUG-199 updated the drain pump driver

  1. … 1 more file in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 5 more files in changeset.
DEN-16683 updated the conductivity sensor temperature compensation calibration enum names

DEN-16683 added code to get and apply the conductivity sensors' temperature compensation calibration record

DENBUG-213 added code to only check the drain pump's direction alarm if the feedback RPM is greater than 0

DEN-16674 updated the temperature sensors calibration record alarm

DEN-16674 made the UV reactors persistent alarm clearance period to 0 ms