dgfirmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DENBUG-236 changed the load cells code to get the tare values from cal data when available

    • -19
    • +5
    /firmware/App/Controllers/LoadCell.c
DENBUG-232 added code to get the reservoirs empty weight from the calibration records and set the reservoirs tare offset to 0 upon transitioning to service mode

    • -8
    • +29
    /firmware/App/Controllers/LoadCell.c
DENBUG-236 changed the mode fill produce diaylsate timeouts to run the concentrate pumps at faster speed

DEN-16782 changed the tare to fabs

DENBUG-236 added code to set the concentrate pumps park status in progress to TRUE

DENBUG-236 added a blank line

DENBUG-236 changed the polarity of the concentrate pumps park progress

DENBUG-236 added code to check the progress of the concentrate pump's park

DENBUG-236 added code to not transition from the fill modes's start state unless both concentrate pumps are parked

DENBUG-236 moved the local variables to the top in Gen Idle

DENBUG-236 changed the code set the reset park alarms to False once the pump started and not to park the concentrate pumps if they are already parked

DENBUG-236 removed the dead code

DENBUG-236 changed the concentrate pumps to park in Gen Idle and also remove the concentrate pumps park alarm

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

    • -1
    • +1
    /firmware/App/Controllers/UVReactors.c
Merged DENBUG-216

DENBUG-216 added code to clear the UV reactors with no flow and UV reactors health alarms when the UV reactor is off

    • -1
    • +7
    /firmware/App/Controllers/UVReactors.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DEN-16782

DEN-16782 updated the code

DEN-16782 changed the empty reservoir weight

DEN-16782 changed the code to set the tare value in the init of the load cells

DENBUG-218 changed the macro of alarm 274 to F32 from U32

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DEN-16769

DEN-16769 updated the VectorCAST test case for the drain pump

DEN-16769 changed the required minimum RPM for the drain pump direction check to 100 RPM

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo