common

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-15404 added the RO permeate sample messages and enums

Add pressureLimitsActive to header.

Add pressureLimitsActive to header.

Add pressureLimitsActive to header.

Add pressureLimitsActive to header.

RESOLVED IN CODE WALKTHROUGH

RESOLVED IN CODE WALKTHROUGH

Originally there BLD communications was going to use an available alarm. The final decision was to repurpose an existing alarm. Hence there were no firmware changes necessary.

Originally there BLD communications was going to use an available alarm. The final decision was to repurpose an existing alarm. Hence there were no firmware changes necessary.

Will always be integers. Prefer to store them that way.

Will always be integers. Prefer to store them that way.

this might be clearer written as: data = MAX( 0.0F, data )

this might be clearer written as: data = MAX( 0.0F, data )

DEN-15359: Added treatment parameter for asymmetric on venous pressure alarm limits.

Could these recently added variables be defined as F32 instead of casting?

Could these recently added variables be defined as F32 instead of casting?

DEN-15367 added a message to signal the user to recover from fault

DEN-15367, DEN-15404 added messages to start and stop the RO permeate sample mode and to allow the user to signal DG to recover from treatment

HD-DEN-15359_Usability Arterial And Venous Pressure Alarm Limits
HD-DEN-15359_Usability Arterial And Venous Pressure Alarm Limits
DEN-15359: Updated tx params enum to change art/ven pressure limit params from min/max to window.

Merge branch 'DEN-13865-fw-duplicate-alarms-occur-during-post-treatment-rinseback-and-block-workflow' into develop

DEN-13865: set dialysate temp alarms and venous bubble alarm to prevent re-trigger.

DG Staging Unreviewed Commits
DG Staging Unreviewed Commits
Merge branch 'DEN-13865-fw-duplicate-alarms-occur-during-post-treatment-rinseback-and-block-workflow' into develop

DEN-13865: Added 2 new alarm properties to prevent alarm re-trigger upon rinseback and end-tx responses to an alarm until treatment resumed or completed back to standby mode.

HD-DEN-13865_FW Duplicate Alarms Occur During Post Treatment Rinseback And Block Workflow
HD-DEN-13865_FW Duplicate Alarms Occur During Post Treatment Rinseback And Block Workflow
DEN-15363 Repurpose alarm ID 63

DEN-15363 Add initial alarm table entry

HD-DEN-15363_FW Handle Bld Sensor Communication Errors
HD-DEN-15363_FW Handle Bld Sensor Communication Errors
DEN-15367 added a message to signal the resume from fault

Merge branch 'staging' into develop

DG-DEN-15367_HD DG Test Configuration Setup
DG-DEN-15367_HD DG Test Configuration Setup
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged DEN-15274