Controllers

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 5 more files in changeset.
RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Done

Done

But this comment also asked that you remove the transition to fill mode here and add it to the fill mode function called above. It's still here.

But this comment also asked that you remove the transition to fill mode here and add it to the fill mode function called above. It's still here.

No I will check the Dialin check in the function like the rest of the commands from Dialin.

No I will check the Dialin check in the function like the rest of the commands from Dialin.

I don't see change. Did you push?

I don't see change. Did you push?

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Done

Done

Done

Done

Done

Done

Done. Added a check in the function in the Mode Fill like the rest of the modes and drivers.

Done. Added a check in the function in the Mode Fill like the rest of the modes and drivers.

Done

Done

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Do this (request fill mode) in the testSetModeFillForCal() function above (and only if Dialin is logged in).

Do this (request fill mode) in the testSetModeFillForCal() function above (and only if Dialin is logged in).

Make sure Dialin is logged in before accepting command.

Make sure Dialin is logged in before accepting command.

If this is a Dialin command, make sure Dialin is logged in before acting on it (throughout this module).

If this is a Dialin command, make sure Dialin is logged in before acting on it (throughout this module).

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

If these are Dialin commands, add a condition around this switch that Dialin has logged in.

If these are Dialin commands, add a condition around this switch that Dialin has logged in.

These are Dialin commands? If so, prefix each enum with CMD_ and clarify this in comment.

These are Dialin commands? If so, prefix each enum with CMD_ and clarify this in comment.

CD1 is used to check the difference between CD1 and CD2. CD1 is not used to check the reading of acid.

CD1 is used to check the difference between CD1 and CD2. CD1 is not used to check the reading of acid.

Will address in DEN-16693.

Will address in DEN-16693.

All of these for loops are not following our coding standards. Should have bracketed scope even if single line of code in loop.

All of these for loops are not following our coding standards. Should have bracketed scope even if single line of code in loop.

Does this mean we aren't checking the CD1 sensor at all?

Does this mean we aren't checking the CD1 sensor at all?

DEN-16683 updated the conductivity sensor temperature compensation calibration enum names