ModeGenIdle.c

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-15660 addressed the code review comments

  1. … 1 more file in changeset.
DEN-15660 addressed the code review comments

  1. … 5 more files in changeset.
DEN-15809 added code to clear the dialysate generation alarm 147

  1. … 2 more files in changeset.
DEN-15809 updated the code to trigger another alarm if the empty bottle alarms have been triggered.:

  1. … 2 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 19 more files in changeset.
Merge branch 'staging' into DEN-15274-hd_dg_test_configuration_setup

  1. … 7 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 13 more files in changeset.
Merge branch 'staging' into DEN-15196-DIAL-251

  1. … 3 more files in changeset.
DIAL-251: DG changes for operation status event handling.

  1. … 13 more files in changeset.
DEN-15274 updated the GenIdle fill target to 0.8 L/min

DEN-15274 fixed the bad fill target volume

  1. … 1 more file in changeset.
DEN-15274 changed the target flow of the GenIdle temporarily

DEN-15274 addressed the code review comments

  1. … 4 more files in changeset.
DEN-15274 addressed the code review comments

  1. … 3 more files in changeset.
DEN-15274, DEN-15246 Added code to not lose the commanded fill volume from HD due to multiple bad fill modes. Updated the heaters code to keep getting the dialysate the flow for the trimmer control. Updated the drain to volume function

  1. … 5 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 8 more files in changeset.
DEN-15246 merged staging

  1. … 2 more files in changeset.
DEN-15246 addressed the code review comments

  1. … 2 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 3 more files in changeset.
DEN-15265 addressed a code review comment

DEN-15265 addressed a code review comment

DEN-15265, DEN-15246 changed the heat disinfect's primary target temperature to 60 C prior to filling with water for the actual heat disinfct. Updated the code to properly exit the bad fill state of the gen idle mode once the bad sequence is finished

  1. … 1 more file in changeset.
DEN-15246 changed the bad fill end of state

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 9 more files in changeset.
DEN-15199 updated the code per the systems requirements. Initial work on the release software configurations

  1. … 2 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 12 more files in changeset.
DEN-14999 merged staging

  1. … 9 more files in changeset.
DEN-14999 updated the code based on the alarms table

  1. … 9 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 7 more files in changeset.
DEN-14834 updated the code to just send the heater command in Idle and Drain if the primary heater is not on. Addressed the code review comments

  1. … 4 more files in changeset.