Modes

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Merge remote-tracking branch 'origin/DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low' into develop

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

Reset timers when doing a test recover state, or returning from a (reset) fault condition.

DIAL-283: compiler fixes.

DIAL-283: message handling for moving average override.

  1. … 3 more files in changeset.
DIAL-283: chem disinfect moving average override

DG-DIAL-283_NO Moving Average Commands Conductivity
DG-DIAL-283_NO Moving Average Commands Conductivity
Merge remote-tracking branch 'origin/DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low' into develop

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

Reintroduced reservoir data structure change.

Corrected the setModeFillStateTransition semantics.

  1. … 1 more file in changeset.
RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Done.

Done.

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

Corrected spacing in the file per CR comments

Add blank line between this code and switch below.

Add blank line between this code and switch below.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Merge remote-tracking branch 'origin/DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low' into develop

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

Follow up for changes, simplifications suggested by Sean.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-16383 updated the code

These fields have been moved to a different broadcast at some point, and were no longer being set by the reservoir data broadcast. The fields regularly contained "NAN" values, so I removed them.

These fields have been moved to a different broadcast at some point, and were no longer being set by the reservoir data broadcast. The fields regularly contained "NAN" values, so I removed them.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

DEN-16383 updated mode flush

Why are these fields removed?

Why are these fields removed?

DEN-16383 fixed the heat disinfect alarm 242 trigger

DG-DEN-16383_Heat Disinfect R1 TO R2 Timer Overflows And Stuck IN State
DG-DEN-16383_Heat Disinfect R1 TO R2 Timer Overflows And Stuck IN State
Merge remote-tracking branch 'origin/DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low' into develop

Done. Code updates pushed.

Done. Code updates pushed.

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

Updated headers

DEN-16314-1-alarm-206-triggers-after-resuming-from-incoming-water-conductivity-high-or-low

fill time allowance for time spent in pause state

Cleared fill timer on transition to generate

Added removed unused (and uninitialized) variables from broadcast data structure.

  1. … 1 more file in changeset.