Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DEN-15182 added a pause state in standby mode for the inlet water conditions. Addressed the code review comments

Please check the code again.

Please check the code again.

Done

Done

Done

Done

Done

Done

This is in the Off state in which RPM being too high occurs when the RPM is greater than the minimum RPM which is 300.

This is in the Off state in which RPM being too high occurs when the RPM is greater than the minimum RPM which is 300.

Done

Done

request will remain if inlet alarms active. is that what we want?

request will remain if inlet alarms active. is that what we want?

Yes we do not support Beta in release.

Yes we do not support Beta in release.

Looks like we will not read ADC channels at all if release build.

Looks like we will not read ADC channels at all if release build.

Why call this "isRPMTooHigh" but compare the rpm against the "MIN_DRAIN_PUMP_RPM"? Between MIN and MAX would be the natural valid range, similar to "isRPMOutOfRange", below.

Why call this "isRPMTooHigh" but compare the rpm against the "MIN_DRAIN_PUMP_RPM"? Between MIN and MAX would be the natural valid range, similar to "isRPMOutOfRange", below.

Needs default or just do if/else.

Needs default or just do if/else.

Needs default or just do if/else.

Needs default or just do if/else.

Yes, fault.

Yes, fault.

Why remove?

Why remove?

DEN-13949 updated heat disinfect valves actuator per SRSDG 504

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DEN-15182 updated the code to handle the inlet water conditions in standby mode

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merged DEN-15166

DEN-15166, DEN-15182 updated the voltages code and fixed the filter flush code to be able to resume after an inlet condition alarm

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DEN-15166 uncommented the voltages alarm

DEN-15166 added the Maxon drain pump RPM and the new non-isolated voltage

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces