Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14604 updated the code to be able to use multiple heat disinfect timers per the new requirements

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14607 addressed the code review comments

DEN-14631 added the inlet water check functions to the POST and Standby modes

DEN-14607, DEN-13999 updated the fill mode the not command the VPo valve to fill state upon exiting the pause state. Updated the pressures driver to assume the overidden pressure is absolute and not add the baro pressure to make it absolute

DEN-14561 Decrease concentrate lines prime from 95 to 60 sec.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merged staging with the latest updates

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 8 more files in changeset.
DEN-14559 removed dead code

DEN-14559 addressed the code review comments

DEN-14559 addressed the code review comments

Merge branch 'staging' into DEN-14559-dg_hd_dev-hd_dg_dvt-update-part-8

    • -13
    • +13
    ./Controllers/TemperatureSensors.c
DEN-14559 updated the code to be able request POST by the Dialin user. Updated the chemical disinfect flush to be able drain the reservoirs all the time

    • -23
    • +22
    ./Modes/ModeChemicalDisinfectFlush.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Merge branch 'DEN-13946-certain-temperature-sensors-trigger-wrong-alarm' into develop

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

DEN-13946 Code review correction

DEN-13676 Correction per code review

DEN-13946 Corrections per code review

    • -22
    • +23
    ./Controllers/TemperatureSensors.h
HD-DEN-14561_Release Preprocessor Flag Specifies Code That Conflicts With SW Config Debug

Corrected _RELEASE_ logic, release build executes the same block as non debug selection

DEN-13946 Make monitor functions for pressure, temperature, thermistors and load cells consistent. Address code review comments.

    • -11
    • +11
    ./Controllers/TemperatureSensors.c
DEN-14559 added functions to reset the POST states of the drivers that have a POST state machine for the command to request POST again