DG.hcg

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
RESOLVED in CODE WALKTHROUGH

RESOLVED in CODE WALKTHROUGH

DG-DEN-3421_DG Heat Disinfection
DG-DEN-3421_DG Heat Disinfection
RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

This a matter of trying the temperature sensors more than once before we start the cycle. Making the wait time longer will not necessarily help the sensors to read within the range.

This a matter of trying the temperature sensors more than once before we start the cycle. Making the wait time longer will not necessarily help the sensors to read within the range.

HalCOGen fixes. Merge fixes.

  1. … 7 more files in changeset.
Reset corrupted HalCOGen source files.

  1. … 1 more file in changeset.
RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

CONC_PUMPS_REVERSE_SPEED_ML_PER_MIN = -30.0 to indicate that the direction is in reverse.

CONC_PUMPS_REVERSE_SPEED_ML_PER_MIN = -30.0 to indicate that the direction is in reverse.

Done.

Done.

Good catch, thanks. I changed it.

Good catch, thanks. I changed it.

I check in the inlet pressure only at the states that are needed. There are times that I am not even pulling water from the inlet line.

I check in the inlet pressure only at the states that are needed. There are times that I am not even pulling water from the inlet line.

It is no longer needed.

It is no longer needed.

2000 uS/cm is a safe value to determine if the acid is inserted in. Due to sensor to sensor variations, we decided to keep it a little lower than its conductivity value is.

2000 uS/cm is a safe value to determine if the acid is inserted in. Due to sensor to sensor variations, we decided to keep it a little lower than its conductivity value is.

Done.

Done.

We should keep this for now in case we wanted to lower the heaters duty cycle to previous limits.

We should keep this for now in case we wanted to lower the heaters duty cycle to previous limits.

These functions are automatically generated once a HET driver is enabled in HALCoGen.

These functions are automatically generated once a HET driver is enabled in HALCoGen.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.