sys_vim.c

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
RESOLVED in CODE WALKTHROUGH

RESOLVED in CODE WALKTHROUGH

DG-DEN-2650_DG Firmware Infrastructure
DG-DEN-2650_DG Firmware Infrastructure
DG Staging Unreviewed Commits
DG Staging Unreviewed Commits
RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

I have the typedef immediately following the associated enum to show they are coupled. Previously I had the typedef included in the enum declaration but Qt didn't like that.

I have the typedef immediately following the associated enum to show they are coupled. Previously I had the typedef included in the enum declaration but Qt didn't like that.

The 4 reservoir valves are controlled by the HD when it's connected and on. In Standby mode, the HD is connected and on.

The 4 reservoir valves are controlled by the HD when it's connected and on. In Standby mode, the HD is connected and on.

Yes, there are 4 DIP switches that go to GPIO input pins on the RM46 that we can use for engineering/test purposes.

Yes, there are 4 DIP switches that go to GPIO input pins on the RM46 that we can use for engineering/test purposes.

There are many more valves on the DG Device, why setting only these ones?

There are many more valves on the DG Device, why setting only these ones?

Do we have dip switches on the DG Board?

Do we have dip switches on the DG Board?

Demoted several interrupts from FIQ to IRQ. Re-ordered IRQ interrupt priorities.

  1. … 12 more files in changeset.
I do remove build flags that I don't need anymore every so often. If we're done with CAN testing I can remove that one. I'm still using the rest of these from time to time.

I do remove build flags that I don't need anymore every so often. If we're done with CAN testing I can remove that one. I'm still using the rest of these from time to time.

I imagine we would settle on a nominal (theoretical) gain/offset here and then apply calibration gain/offset from NV memory afterward to get a final conversion.

I imagine we would settle on a nominal (theoretical) gain/offset here and then apply calibration gain/offset from NV memory afterward to get a final conversion.

Clean up

Clean up

What is our plan to adjust these constants across machines?

What is our plan to adjust these constants across machines?

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Done

Done

Done

Done

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.