firmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
RESOLVED IN CODE WALKTHROUGH.

RESOLVED IN CODE WALKTHROUGH.

I think VPi is closed during standby mode, so not sure why we want to check inlet conductivity in this mode. I imagine new system would get installed by service - would need some kind of priming do...

I think VPi is closed during standby mode, so not sure why we want to check inlet conductivity in this mode.
I imagine new system would get installed by service - would need some kind of priming done in service mode, so I'm not worried about that.

will these alarms trigger with open air? Ex: if a user has a device shipped to them, will they be greeted with conductivity alarms on first power up before any water has ran through the system? If...

will these alarms trigger with open air?

Ex: if a user has a device shipped to them, will they be greeted with conductivity alarms on first power up before any water has ran through the system? If so, how will they be able to fix it?

Done. Does HD communicating always account for UI traffic as well?

Done. Does HD communicating always account for UI traffic as well?

Done

Done

Reverted.

Reverted.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

I think if HD not communicating, just clear the pending ack list - when HD revives, any pending messages in here are likely moot.

I think if HD not communicating, just clear the pending ack list - when HD revives, any pending messages in here are likely moot.

I think it's better to end the if not POST body after the retries decrement (so don't use up retry during post, but still resend msg).

I think it's better to end the if not POST body after the retries decrement (so don't use up retry during post, but still resend msg).

No need to increase this one.

No need to increase this one.

I don't see it, but resolving anyway. RESOLVED in CODE WALKTHROUGH.

I don't see it, but resolving anyway.
RESOLVED in CODE WALKTHROUGH.

DG-DEN-14788_Dial 222 Sys Request
DG-DEN-14788_Dial 222 Sys Request
DG-DEN-15016_System Faults During Treatment Then Returns TO The Standby Screen
DG-DEN-15016_System Faults During Treatment Then Returns TO The Standby Screen
Spaces inside (). And explicit condition (i.e. ( TRUE == isConvNotValid ).

Spaces inside (). And explicit condition (i.e. ( TRUE == isConvNotValid ).

Corrected

Corrected

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Done

Done

I did. I still see a call to sendAckResponseMsg() and I don't think it should be here.

I did. I still see a call to sendAckResponseMsg() and I don't think it should be here.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

Check the diff of the last two commits.

Check the diff of the last two commits.

What I meant is that we don't need to send anything other than response.

What I meant is that we don't need to send anything other than response.

Done

Done

Remove TODO?

Remove TODO?

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.

RESOLVED in CODE WALKTHROUGH.