Modes

Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14999: Removed minimum UF change. Added 250ms of persistence to HD fluid leak alarm. Increased no ack retries from 8 to 10 because UI needed more time at startup. Accept UI check-in message regardless of payload size because UI is sending 2 different flavors of check-in message.

  1. … 3 more files in changeset.
DEN-14999: Do not alarm after rinseback completed due to 15 min t/o.

Merge DEN-14860

  1. … 2 more files in changeset.
Fixed merge conflicts from DEN-14999.

  1. … 6 more files in changeset.
Reverted previous change to re-enable re-prime feature and allow zero UF rate.

  1. … 1 more file in changeset.
Re-Prime feature re-enabled for this build. Minimum UF rate set back to zero for this build.

  1. … 1 more file in changeset.
Fixed merge conflicts.

  1. … 7 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 11 more files in changeset.
DEN-14906: fixed merge conflicts from staging.

  1. … 8 more files in changeset.
Merge branch 'staging' into DEN-14999-alarm-table-updates

DEN-14999: Fixed issue with repeated trimmer heater commands being sent to DG.

  1. … 2 more files in changeset.
Merge branch 'DEN-14906-dialyzer-de-prime' into develop

  1. … 1 more file in changeset.
DEN-14906: Fixed isues that arose when disabling re-prime feature.

  1. … 1 more file in changeset.
Merge DEN-14457-reservoir-drains-before-treatment-with-pre-treatment-build-flags-off

Cherry picked merge, due to staging/develop conflicts

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

HD-DEN-14457_Reservoir Drains Before Treatment With Pre Treatment Build Flags Off

Integrated current changes in other branches to address apparent conflicts.

DEN-14906: Increased HD pump max current persistence from 2 to 5 seconds. Added 1 minute delay following start/resume of dialysis where venous pressure limits are set to max selectable to allow pumps to stabilize.

  1. … 5 more files in changeset.
Auto stash before merge of "DEN-14457-reservoir-drains-before-treatment-with-pre-treatment-build-flags-off" and "staging"

Merge branch 'staging' into DEN-14457-reservoir-drains-before-treatment-with-pre-treatment-build-flags-off

DEN-14906: restored 30 min interval for dialyzer re-prime.

DEN-14906: Increased pump speed during dialyzer re-prime and reduce time in re-prime state in attempt to address over-current alarm.

DEN-14860 Fix config bug. If Dry tests disabled, got stuck in Prime because DG Allow Flush/Fill signals not set.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 6 more files in changeset.
HD-DEN-14457_Reservoir Drains Before Treatment With Pre Treatment Build Flags Off

Updated signalAllowDGFlushFills(),

signalAllowDGFillRes[12]() to be sure that the signal to continue occurs even when both thr air pump and dry tests are disabled.

DEN-14906: Added delay before resuming dialyzer re-prime to allow DPi to stop to prevent pressure spike.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14888: Fix issue with initializing start/final reservoir volumes.

DEN-14906: Handle UF pause and auto-resume for dialyzer re-prime.

Merge branch 'staging' into DEN-14763-dg_hd_dev-hd_dg_dvt-update-part-10

  1. … 3 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 7 more files in changeset.