Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14788: code review comments.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-14906: Increased pump speed during dialyzer re-prime and reduce time in re-prime state in attempt to address over-current alarm.

DEN-14999: Reduced BP occlusion clear threshold from 5500 to 5000 above baseline.

Merge branch 'staging' into DEN-14788-DIAL-242-air-bubble-sensor

DEN-14788: fixed UI check-in.

DEN-14860 Fix config bug. If Dry tests disabled, got stuck in Prime because DG Allow Flush/Fill signals not set.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

HD-DEN-14457_Reservoir Drains Before Treatment With Pre Treatment Build Flags Off

Updated signalAllowDGFlushFills(),

signalAllowDGFillRes[12]() to be sure that the signal to continue occurs even when both thr air pump and dry tests are disabled.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-14788: DIAL-242: added check for bubble sensor override.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-14906: Added delay before resuming dialyzer re-prime to allow DPi to stop to prevent pressure spike.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14888: Fix issue with initializing start/final reservoir volumes.

Merge branch 'DEN-14892-add-bootloader-to-existing-dg-firmware' of ssh://dvm-linux02:7999/hd/hdfirmware into origin/DEN-14892-add-bootloader-to-existing-dg-firmware

    • -180
    • +192
    ./Services/SystemCommMessages.c
DEN-14906: Handle UF pause and auto-resume for dialyzer re-prime.

Merge branch 'staging' into DEN-14763-dg_hd_dev-hd_dg_dvt-update-part-10

    • -174
    • +186
    ./Services/SystemCommMessages.c
DEN-14860 Fix calculations by using proper settle times for fresh and used cartridges. Remove zero wait to fill above 400mlp.

DEN-14860 Fix linear interpolation calculation.

DE-14860 Move calculation of recirculationLevelPct so always updated. Fix misspelled value tempRemoveTargetFillFlow.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-14763 addressed the code review comments

Merge branch 'DEN-14906-dialyzer-de-prime' into develop

DEN-14906: Restored 30 minute interval for dialyzer re-prime. Reduced re-prime time from 40 to 35 seconds. Fixed so treatment time is paused during dialyzer re-prime.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo