firmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-14906: Increased pump speed during dialyzer re-prime and reduce time in re-prime state in attempt to address over-current alarm.

DEN-14999: Reduced BP occlusion clear threshold from 5500 to 5000 above baseline.

Merge branch 'staging' into DEN-14788-DIAL-242-air-bubble-sensor

    • -6
    • +134
    ./App/Services/SystemCommMessages.c
DEN-14788: fixed UI check-in.

DEN-14860 Fix config bug. If Dry tests disabled, got stuck in Prime because DG Allow Flush/Fill signals not set.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

HD-DEN-14457_Reservoir Drains Before Treatment With Pre Treatment Build Flags Off

Updated signalAllowDGFlushFills(),

signalAllowDGFillRes[12]() to be sure that the signal to continue occurs even when both thr air pump and dry tests are disabled.

Aligned memory with sector boundaries

Aligned memory with sector boundaries

Aligned memory with sector boundaries

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-14788: DIAL-242: added check for bubble sensor override.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

DEN-14906: Added delay before resuming dialyzer re-prime to allow DPi to stop to prevent pressure spike.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14888: Fix issue with initializing start/final reservoir volumes.

Merge branch 'DEN-14892-add-bootloader-to-existing-dg-firmware' of ssh://dvm-linux02:7999/hd/hdfirmware into origin/DEN-14892-add-bootloader-to-existing-dg-firmware

    • -180
    • +192
    ./App/Services/SystemCommMessages.c
    • -2
    • +76
    ./App/Services/SystemCommMessages.h
Added project file

Added project file

Added project file

Rearrange stack location

Rearrange stack location

Rearrange stack location

DEN-14906: Handle UF pause and auto-resume for dialyzer re-prime.

Merge branch 'staging' into DEN-14763-dg_hd_dev-hd_dg_dvt-update-part-10

    • -174
    • +186
    ./App/Services/SystemCommMessages.c
    • -2
    • +76
    ./App/Services/SystemCommMessages.h
DEN-14860 Fix calculations by using proper settle times for fresh and used cartridges. Remove zero wait to fill above 400mlp.

DEN-14860 Fix linear interpolation calculation.

DE-14860 Move calculation of recirculationLevelPct so always updated. Fix misspelled value tempRemoveTargetFillFlow.