Please add Alarm
ALARM_ID_TD_PRIME_COMPLETED_HIGH and ALARM_ID_TD_SOFTWARE_FAULT

Add alarm ALARM_ID_TD_PRIME_COMPLETED_MEDIUM

Please add currentPreTreatmentState to inputs.

currentPreTxRecircState looks like an input.

Put recirc state after Rx state (both here in switch statement and also in enumeration).

Put in alphabetical order (before Timers.h).

Where do we trigger high priority prime completed alarm?

Dialysate rate should be set to the Qd user setting (from Tx params).

Add /// doxygen comment for this enumeration and ///< doxygen comments to right of each enum in the list.

Should this check be moved to the fluid bolus exec function?

It looks like you have this as a T/F response from UI. UI should not be determining whether the modality matches - that's our job. UI should be telling us which type of tubing set was installed (HD or HDF type). Then when we get this response msg from UI, we will compare the type to the user selected modality (from TxParams) to see if it matches.

Add doxygen comments to the right of each structure field.

Why is this commented out? We will get stuck in this state if we don't move on to the pressure leak test states.

For now, we need to set authResponseReceived and authResponseValidTubingSet and authResponseModalityAccepted to TRUE until UI is properly responding to authentication request (TODO).

For now, we need to set barcodeScanResponseReceived to TRUE here until barcode scan command is implemented.

Add blank line before return statement.

Keep this blank line above group header.

Something is wrong here. We already had reg 33 at line 192 above. Reconcile with HDD.

Make sure UI s/w is looking for this message on the broadcast channel or change this channel to the TD=>UI channel if UI is looking for this message on that channel.

Maintain alphabetical order.

Eliza says we do allow multiple iso UF sessions in a treatment. So do we still need this else if, but looking at <= iso UF elapsed session time?

What about HDF?

Once UI software sends the volume and/or duration change request and once we change them, the UI software will send another request to confirm the displayed settings to the user and that is what is being handled in this function.