Clone Tools
  • last updated a few minutes ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Merge branch 'staging' into DEN-14763-dg_hd_dev-hd_dg_dvt-update-part-10

DEN-14763 updated the code per the requirements

    • -6
    • +34
    ./Modes/ModeHeatDisinfectActiveCool.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14763 changed the duration of the mix drain timeout to 4 minutes per the requirements

DEN-14763 addressed the code review comments

DEN-14763 merged staging

Merge branch 'DIAL-243-integrated-volume-is-not-working' into DEN-14788-DIAL-243-integrated-volume-is-not-working

DEN-14763 addressed the code review comments

    • -20
    • +29
    ./Modes/ModeHeatDisinfectActiveCool.c
Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14763, DEN-14960 added an event to report the reservoir base weight and filled volume at the end of the fill mode.

DEN-14763 addressed the code review comments'

  1. … 2 more files in changeset.
DEN-14689: Fixed duplicate case

DEN-14689: sync'd out of message naming

DEN-14763 updated the heat disinfect active cool per the requirements

    • -24
    • +38
    ./Modes/ModeHeatDisinfectActiveCool.c
DIAL-243: Fixed header.

DIAL-243: fixed integrated volume data type from u32 to f32

DEN-14763 addressed the code review comments and added inlet water conditions to the heat disinfect active cool

    • -43
    • +210
    ./Modes/ModeHeatDisinfectActiveCool.c
DEN-14763 work in progress continued working on the heat disinfect active cool mode

    • -91
    • +87
    ./Modes/ModeHeatDisinfectActiveCool.c
DEN-14689: sync msg_ids with msgdefs.h

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'staging' into DEN-14763-dg_hd_dev-hd_dg_dvt-update-part-10

DEN-13154: Added raw flow rates to DG flow broadcast messages.

Bamboo Commit: Updated DGCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-14834 updated the code to just send the heater command in Idle and Drain if the primary heater is not on. Addressed the code review comments

Merge branch 'staging' into DEN-14834-ro-flow-drops-to-zero-and-cp-measured-speed-1500-temporarily-during-pre-treatment

DEN-14834 updated that get target primary heater function to accomodate the changes from pre-treatment. Removed the range check from the drain pump measured RPM

    • -14
    • +17
    ./Controllers/TemperatureSensors.c