BloodFlow.c

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 10 more files in changeset.
Merge branch 'staging' into DEN-15104-hd-fpga-communications

# Conflicts:

# firmware/App/Controllers/BloodFlow.c

  1. … 4 more files in changeset.
DEN-15014 Changes to support FPGA testing. Move FE and OE SCI faults to FPGA communications alarm.

  1. … 8 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 13 more files in changeset.
DEN-15199 renamed the test configuration enums

  1. … 2 more files in changeset.
DEN-15199 work in progress continued implementing the test configurations code

  1. … 9 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-15203: Fixed alarm 32 to consider reverse direction with measured motor speed.

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 30 more files in changeset.
DEN-14999 updated the alarms table

  1. … 20 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 20 more files in changeset.
DEN-14999: Removed BP and DPi flow range checks.

  1. … 1 more file in changeset.
Fixed merge conflict from staging.

  1. … 4 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 15 more files in changeset.
DEN-14906: fixed merge conflicts from staging.

  1. … 11 more files in changeset.
DEN-14999: Fixed alarm mgmt issue where top alarm may not be set if LOW priority alarm triggered. Ensure HD pump on flag is set to FALSE when pump controller is in off state.

  1. … 3 more files in changeset.
DEN-14906: Increased HD pump max current persistence from 2 to 5 seconds. Added 1 minute delay following start/resume of dialysis where venous pressure limits are set to max selectable to allow pumps to stabilize.

  1. … 6 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 14 more files in changeset.
DEN-13154: Addressed code review comments.

  1. … 3 more files in changeset.
DEN-13154: Removed dry self-test timeout alarm. Fixed bug DEN-14884.

  1. … 2 more files in changeset.
DEN-13154: Added prescribed flow rates to blood and dialysate flow broadcast messages per DEN-13152.

  1. … 4 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 6 more files in changeset.
Fixed merge conflicts with local merge from staging.

  1. … 5 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 46 more files in changeset.
DEN-14549: Added function to see if an alarm condition is detected. Added a function to determine whether A/C power loss condition is detected and used them where needed.

  1. … 7 more files in changeset.
DEN-14549: clear treatment version of ac power loss alarm too when ac is restored. prevent pump current alarms when ac power loss in treatment is active too.

  1. … 3 more files in changeset.
HD-DEN-14561_Release Preprocessor Flag Specifies Code That Conflicts With SW Config Debug

Corrected _RELEASE_ logic, release build executes the same block as non debug selection

  1. … 3 more files in changeset.
Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

  1. … 112 more files in changeset.
DEN-14007: Addressed code review comments.

  1. … 2 more files in changeset.
DEN-14007: Tentative fix for DEN-13688 for pump homing consistency - set all pumps to same speed while homing.

  1. … 5 more files in changeset.