firmware

Clone Tools
  • last updated a few seconds ago
Constraints
Constraints: committers
 
Constraints: files
Constraints: dates
DEN-15367 merged staging

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-15367 addressed a code review comment

DEN-15489 updated the code that checks for the validation dates

DEN-15367 addressed the code review comments. Added code to check the payload of the message that is received from DG to indicate that DG is ready to dispense more water in RO permeate sample mode

DEN-15558: Addressed code review comment.

DEN-15558: Extend exemption for venous low pressure alarm during air trap fill for 5 seconds after fill to allow pressure to recover.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merge branch 'DEN-15363-fw-handle-bld-sensor-communication-errors' into staging

DEN-15558: Finished restore of original BP speed during dialyzer prime.

DEN-15558: Reversed temporary change in dialyzer prime BP speed. Increased max venous pressure from 300 to 400 mmHg.

DEN-15558: temporary slow down of BP during pre-tx dialyzer prime state to see if helps with blood leak issue.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-15459 changed the blood leak alarm detection to not trigger if the HD mode is not in treatment

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

Merged staging to DEN-15278.

Bamboo Commit: Updated HDCommon.h with build versions from Bamboo

Bamboo Commit: Updated the Copyright section and replaced tabs with 4 spaces

DEN-15493 Update Rinseback flow rate range to 100-300, default 200. Old was 50-150, default 75.

DEN-15278: Addressed code review comment.

Merge branch 'staging' into DEN-15363-fw-handle-bld-sensor-communication-errors

DEN-15278: no countdown timer if alarm 165 (blood sitting too long) is active.

DEN-15367 addressed the code review comments

DEN-15440 added code to partial drain the reservoirs in patient connect state machine in pretreatment